User manual RYOBI IDC400-SERIAL-801087301-809065150

[. . . ] ⷠWhen working with the unit, use the safety attachments supplied. ⷠBefore starting, adjust the handle to your size. All interventions, whether for maintenance, repair or for changing cutting head or safety attachments, must be undertaken with the motor stopped. ⷠFrequently inspect the condition of the cutting head, All damaged parts must immediately be replaced. [. . . ] ⷠFrequently inspect the condition of the cutting head, All damaged parts must immediately be replaced. ⷠFollow all the required precautions when undertaking replacement. ⷠUse only replacement parts recommended by the manufacturer. ⷠAll guards must be installed properly before operating the unit. Keep unit clean of vegetation and other materials. ⷠKeep connecting wires away from the tools. ⷠTurn off the unit and pull the main plug before set-up or cleaning of the unit, and before testing for tangled or damaged wires. The unit must not be used if the connecting wires are not in perfect condition. ⷠMaintenance/servicing and cleaning of the unit or adjustments to cutting height or work height may only be performed when the motor is off/still and the main plug is disconnected. ⷠCord Sets - Make sure your cord set is in good condition. The life of your cutting line depends on your trimming techniques, what is being cut, and where the cutting is being done. some line breakage will occur from: · Entanglement with foreign matter · INSTALLING A NEW TRIMMING LINE The trimming line may be replaced by two methods - rewinding the existing reel or installing a prewound reel. Use a clean cloth to clean the inside of the outer spool (Fig. Check the indexing teeth on the reel and spool for wear (Fig. Insert the ends of new trimming line into the inner reel holes (Fig. Loop the line into two equal lengths before inserting it into the holes. Wind the line, in even and tight layers (Fig. Push the ends of the line into the slots (Fig. Insert the ends of the line through the eyelets in the outer spool (Fig. Grasp the ends and pull firmly to release the line from the slots in the spool. [. . . ] Push the ends of the line into the slots (Fig. Insert the ends of the line through the eyelets in the outer spool (Fig. Grasp the ends and pull firmly to release the line from the slots in the spool. Do not use strong detergents on the plastic housing or handle. [. . . ]