User manual RYOBI OPS-1801

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. WARNING The tools should be operated with the ONE+ battery pack. When using battery operated tools basic safety precautions should always be followed to reduce the risk of fire, leaking batteries and personal injury, including the following. Read all these instructions before operating this product and save these instructions. [. . . ] Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire. WARNING Failure to remove the battery pack from the pole pruner could result in accidental starting which could possibly cause serious personal injury. If not positioned correctly the mounting clamp will not hold the blade securely. Tighten the blade retaining screw securely with blade wrench. Remove the blade from the unit, making sure the blade clears the mounting clamp pin. Before attempting to use the pole pruner, familiarize yourself with all operating features and safety requirements. WARNING If any parts are missing, do not operate your pole pruner until the missing parts are replaced. Failure to do so could result in possible serious personal injury. Place the battery pack in your pole pruner. align raised rib on battery pack with groove in pole pruner's battery port. Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in pole pruner before beginning operation. Locate latches of battery pack and depress to release the battery pack from the pole pruner. Lower shaft should now be free to slide down from inside the upper shaft. Make sure the shaft is pulled out to the desired position. Lay the pole pruner on the ground and ensure that no objects or obstructions are in immediate vicinity which could come in contact with the blade. Release the trigger lock button and continue to squeeze the trigger for extended operation. The following steps should be followed to prevent damage to tree or shrub bark. - The first cut should be a shallow cut (1/4 of the limb diameter) on underside of limb or trunk. - The second cut should be made from the top side of the limb outboard from first cut. Keep the unit at full throttle the entire time you are cutting. For second and final cuts (from top of limb or branch), hold the front cutting guide against the limb being cut. [. . . ] Now make your final cut smoothly and neatly against the main member so the bark will grow back to seal the wound. WARNING Never climb into a tree to limb or prune. Do not stand on ladders, platforms, a log or in any position which can cause you to lose your balance or control of the unit. WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. [. . . ]