User manual RYOBI P130

[. . . ] 10 INTRODUCTION This tool has many features for making its use more pleasant and enjoyable. Safety, performance, and dependability have been given top priority in the design of this product making it easy to maintain and operate. 2 SAFETY RULES FOR CHARGER WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. n Before using battery charger, read all instructions and cautionary markings in this manual, on battery charger, battery, and product using battery to prevent misuse of the products and possible injury or damage. [. . . ] 12 V, DC only Charge Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 hour Cord Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 ft. P130 UNIVERSAL CAR CHARGER SINGLE PORT BATTERY RECEPTACLE CORD DEEPLY DISCHARGED OR DEFECTIVE BATTERY (YELLOW LED ON - RED FLASHING) FULLY CHARGED (GREEN LED ON) / CHARGING (GREEN FLASHING LED) QUICK CHARGING (RED LED ON) / EVALUATING (RED FLASHING LED) Fig. 1 CIGARETTE LIGHTER CONNECTOR POWER "ON" (RED LED) KNOW YOUR CHARGER See Figure 1. Before attempting to use this product, familiarize yourself with all operating features and safety rules. LED DISPLAY The LED lights located next to each battery port indicate the charge status of each battery. THERMAL PROTECTION Your single-port charger has a thermal protection system that prevents charging batteries that are too hot, which could cause damage to the battery and a loss of run-time. CIGARETTE LIGHTER CONNECTOR Connector used to energize charger using cigarette lighter receptacle or "power point. " 5 ASSEMBLY UNPACKING This product has been shipped completely assembled. n Carefully remove the charger and any accessories from the box. Make sure that all items listed in the packing list are included. n Inspect the charger carefully to make sure no breakage or damage occurred during shipping. n Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool. n If any parts are damaged or missing, please call 1-800-525-2579 for assistance. WARNING: If any parts are missing do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. PACKING LIST Single-Port Universal Car Charger Operator's Manual Warranty Registration Card OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. LED FUNCTIONS OF CHARGER LED WILL BE ON TO INDICATE STATUS OF CHARGER AND BATTERY PACK: See Figure 2. n Red Power LED on = Charger is getting power from cigarette lighter receptacle or powerpoint. n Green LED flashing = Charging n Green LED on = Fully charged and in maintenance charge mode. n Red LED flashing = When battery pack is inserted into charger, indicates hot battery pack or that battery pack is out of normal temperature range or is evaluating. n Yellow LED on and Red LED flashing = Deeply discharged or defective battery pack. n Yellow LED flashing = This is a High and Low input voltage shutdown. If the cigarette adapter plug voltage is above 15Vdc or below 10Vdc the charger will stop charging. If input voltage is between 10. 5Vdc and 10Vdc, the yellow LED will flash and alarm will sound. NOTE: There is a low input voltage audible alarm for less than 10. 5Vdc input. You should start your car to recharge the vehicle battery and/or remove the charger adapter plug to stop the charging before the car battery is completely drained. n No LED on = Defective charger or battery pack. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. APPLICATIONS You may use this charger for the following purposes: n Portable charging of Ryobi 7. 2 volt-18. 0 volt batteries. CAUTION: If at any point during the charging process none of the LEDs are lit, remove the battery pack from the charger to avoid damaging the product. Return the charger and battery to your nearest service center for service or replacement. 6 OPERATION CHARGING A COOL BATTERY PACK If battery pack is within normal temperature range, the red LED on charger will come on. [. . . ] Do not attempt to destroy or disassemble battery pack or remove any of its components. Nickel-cadmium batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may result. Failure to comply with these warnings could result in fire and/or serious injury. 9 OPERATOR'S MANUAL SINGLE PORT UNIVERSAL CAR CHARGER P130 · SERVICE Now that you have purchased your tool, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorized Service Center. [. . . ]