User manual RYOBI PD-161VR

[. . . ] ß Do not touch any electrical switch. ß Do not use any phone in your building. ß Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. [. . . ] The flame should light within 4 seconds. Even once the flame is lit, the ignition will continue to click for a few seconds for safety. If the burner does not light, repeat the process. If the burner does not light on the second attempt, turn the control knob to "ß" and see "Frequently asked questions". ^ Adjust the knob to the desired setting. The proper pan size will also improve efficiency. ­ Do not use small pans with high flame settings, the flames may climb the sides of the pan. ­ Pots with a smaller diameter than the pan support and pots that do not sit securely (without wobbling) are hazardous and should not be used. Wok burners You can use a wok on these burners without any additional rings, trivets, etc. If you wish to use the wok ring, for extra stability, attach it as shown (depending on your grates). 15 Using the cooktop Safety feature This appliance is equipped with an Ignition Safety Control. This control cuts the gas supply if the flame goes out and reignition is unsuccessful. ^ To reignite the burner, turn the control knob to "ß", then follow the procedure outlined in "Turning on and off / Regulating". Reassembling the wok burner a b c d e Reassembling the normal and fast burners ^ Place the burner head, d, onto the burner base, e. ^ Fit the large burner cap, b, onto the burner head, d. ^ Put the grates in place. a b Be careful not to mix up the parts. Make sure that all the locating tabs and notches align exactly. ^ Place the burner cap, a, onto the burner base, b, so that the notches fit into the holes (see arrows). 18 Frequently asked questions , Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. The burners do not ignite after several attempts. Possible fault ­ The burners are assembled incorrectly. ­ The burners are wet and soiled and/or the flame holes in the burners are soiled and clogged. ­ The cooktop is not plugged in and the circuit breaker has tripped. Fix ­ Reassemble the burners as shown in "Cleaning and Care - Burners". ­ Plug the cooktop in and restore power. [. . . ] In Massachusetts a licensed plumber / gas fitter is required. This appliance must be installed with its own shut off valve and the included gas pressure regulator. Both the valve and the regulator must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. This appliance and its individual shut off valve must be disconnected from the gas supply during any pressure testing of that system performed in excess of ½ psi (3. 5 kPa). [. . . ]