User manual RYOBI PD1410AVR

[. . . ] Selections range from 0 for straight reciprocating blade action to 3 for largest orbit of blade. When cutting into wood and plastic or other soft materials, a large swing is required, i. For steel and similar hard materials, the cutting action should not be as great, so position 0 should be used. However, if a sharp and precise cutting surface is required for soft materials, then position 0 may also be used. [. . . ] However, if a sharp and precise cutting surface is required for soft materials, then position 0 may also be used. It is also intended for thin materials, as well as for knife or rasp work. Make sure that the tool is only connected to the voltage marked on the name plate. Never use the tool if its cover or any bolts are missing. If the cover or bolts have been removed, replace them prior to use. Maintain all parts in good working order. Always secure tools when working in elevated positions. Never touch the blade, drill bit, grinding wheel or other moving parts during use. Never start a tool when its rotating component is in contact with the work piece. Never lay a tool down before its moving parts have come to a complete stop. Then slowly lower the moving blade against the board. For materials other than wood, a starting hole must be drilled first. Socket head bolt (9) at the bottom of the base by using the hex. Next align bottom line of the housing to the angle scale provided on the base plate, and then fasten the hex. Accurate straight cutting can be performed by using the guide fence (10). This steel sheet can be cut by supporting the sheet with the end of the guide. Accurate circle cutting can be done by using the guide fence. Turn the guide fence upside down, and insert the guide pin(11)into the hole. Anti-splintering mode can be achieved by turning the reversible base. Socket head bolt (9) at the bottom of the base (12). [. . . ] Turn the guide fence upside down, and insert the guide pin(11)into the hole. Anti-splintering mode can be achieved by turning the reversible base. Socket head bolt (9) at the bottom of the base (12). Turn the base 180° to put the blade in the anti-splinter slot to help minimize splintering. [. . . ]