User manual RYOBI PD1930I SCHEMA ELECTRIC

[. . . ] ß Do not touch any electrical switch. ß Do not use any phone in your building. ß Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. [. . . ] If the burner does not light at the second attempt, turn the control knob to "ß" and see "Frequently asked questions". ^ Now you can adjust the knob to the desired setting. Turning off ^ Turn the control knob clockwise to "ß". This stops the flow of gas and turns off the cooktop. The knob must only be turned left to turn the appliance on and right to turn it off. If the knob is turned: - on without pressing it down first, - clockwise past the 12 o'clock position, or - counterclockwise past the smallest flame symbol, parts of the cooktop may be damaged. The manufacturer cannot be held responsible for these damages. 12 Using the cooktop Regulating the wok burner The inner and outer burners are both controlled by one control knob. There is a stop at the 6 o'clock position that requires you to press the knob down while turning it in order to get from the high flame to the low flame zone. ^ To reduce the flames from a high to low setting, turn the control knob counterclockwise until you feel resistance. This safety feature is not operated by electricity, it will be active even if the appliance is in use during a power failure. Using the cooktop during a power failure If there is an interruption to the electrical supply the gas can be ignited using a match. ^ Press down and turn the desired control knob counterclockwise to the largest flame symbol. ^ While holding down the knob, light the gas at the burner with a match. ^ When the flame appears, keep the control knob pressed in for 8 - 10 seconds to allow for the Ignition Safety Control to reach operating temperature. 15 Cleaning and care Grates, Control Knobs Do not use a steam cleaner to clean this cooktop. Make sure that all the locating tabs and notches align exactly. ^ Place the burner head, b, onto the burner base, a, so that the Ignition Safety Control and ignitor extend through their respective holes. Reassembling Auxiliary, Normal and Fast burner 17 Cleaning and care Reassembling the wok burner Be careful not to mix up the parts. Make sure that all the locating tabs and notches align exactly. ^ Place the burner head, c, onto the burner base, d, so that the ignitor, e, and the Ignition Safety Control, f, extend through their respective holes in the burner head. The burner head must click into place correctly. ^ Replace the burner cap, a. 18 Frequently asked questions , Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. The burners do not ignite after several attempts. Possible fault ­ The burners are assembled incorrectly. ­ The burners are wet and soiled and/or the flame holes in the burners are soiled and clogged. [. . . ] Both the valve and the regulator must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. This appliance and its individual shut off valve must be disconnected from the gas supply during any pressure testing of that system performed in excess of ½ psi (3. 5 kPa). The appliance must be isolated from the gas supply line by closing its individual manual shut off valve at test pressures equal to or less than ½ psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. [. . . ]