User manual RYOBI POWER KIT: 570W JIGSAW EJS570FK

[. . . ] b) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. c) Keep children and bystanders away while operating a power tool. Distractions can cause you to loose control. [. . . ] Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. c) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventative safety measures reduce the risk of starting the power tool accidently. 1 GENERAL POWER TOOL SAFETY WARNINGS d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. Check for misalignment of binding or moving parts, breakage of parts and any other condition that may affect the power tools' operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits etc. , in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö Following this rule will reduce the risk of eye injury. Wear a face or dust mask if the operation is dusty. Wear hearing protection during extended periods of operation. If using an extension lead, ensure that the male and female plug connection is elevated and out of the way of any water contact. ¡ö ¡ö SUGGESTIONS FOR PROPER USE OF THE JIGSAW OPERATION The switch can be maintained in the operating position by using the lock-on button. The lock-on button can be released by pressing the on/off switch once more. ELECTRONIC SPEED REGULATION (Fig. 4) extraction system will work most effectively when the safety guard is in its down position. They must be open at all times for proper motor cooling. POCKET CUTTING Cut at an even rate and take care not to over load the saw. Excessive force on the saw will prevent the pendulum action operating correctly and reduce the cutting efficiency. Drill a 12mm diameter hole to start an enclosed pocket cut. [. . . ] Always replace the allen key in the allen key holder above the base plate immediately after use. (Fig. 7) ¡ö ¡ö ¡ö This power tool normally requires no maintenance, however, lubricating the guide roller from time to time with a drop of oil will extend the life of the roller. Do not make any adjustment while the motor is in motion. Always disconnect the electrical cord from the power source before mounting a jigsaw blade, changing brushes, or lubricating. [. . . ]