User manual RYOBI R502I SCHEMA ELECTRIC

[. . . ] To prevent appliance damage, the cabinetry and venting hood should be installed first. The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion. The cooktops should only be installed in the illustrations, while maintaining the required safety distances shown. [. . . ] Do not install the cooktop between two tall cabinets, this is a fire hazard. a = Minimum safety distances: KM 400 = 2" (50 mm) KM 402 / 403= 2" (50 mm) KM 408-1 = 2" (50 mm) KM 410 / 411 =10" (250 mm) Deep fryers must not be installed next to gas cooktops. A distance of at least 12" (305 mm) should be maintained between these two appliances. recommended not recommended not allowed 4 IMPORTANT SAFETY INSTRUCTIONS Cooktops should not be installed above a dishwasher, washer, dryer, freezer or refrigerator. The high temperatures radiated downwards from the cooktops could damage these appliances. This equipment has not been designed for maritime use or for use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for an installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. Make sure that the power cord to the cooktop does not come into contact with any mechanical parts once the cooktop has been installed. Safety distance above the appliances As a general rule there must be a minimum safety distance of at least 30 inches (760 mm) between the top of the appliance and any cabinet above it, b. Do not allow the spring clamps to "float", they must be securely fastened. The screws are not necessary for granite countertops. 11 Installation Locking the appliance into place Make sure the cooktops are aligned correctly before setting them into the countertop. Once the spring clamps are engaged, a special tool is required to release the cooktop from the clamps. ^ Guide the power cord through the cut out and connect the appliance to the electrical supply. ^ Position the cooktop over the cut out. With a hand on each side, above the clamps, a, press the cooktop down, locking it into the spring clamps. Make sure that the cooktop rim lies flat against the countertop on all sides. 12 Installation Important The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or the appliance may be damaged if the cooktop needs to be removed for maintenance or service. 13 Electrical connection , WARNING: Disconnect the appliance from the main power supply before servicing. To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. [. . . ] To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. To guarantee the electrical safety of this appliance; continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. [. . . ]