User manual RYOBI RCT350 SCHEMA ELECTRIC

[. . . ] To prevent damage to the cooktop, the cabinetry and venting hood should be installed first. Gas appliances should only be installed in a well ventilated area. The countertop must be bonded with heat resistant (212 °F / 100 °C) adhesive to prevent distortion or dissolving. The cooktops should only be installed as shown in the illustrations, while maintaining the required safety distances shown. [. . . ] This appliance must be disconnected from the gas supply during any pressure testing performed in excess of 1/2 psi (3. 5 kPa). The machine must be isolated at test pressures equal to or less than 1/2 psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion. Safety distances above the cooktop There must be a minimum safety distance of at least 30 inches (760 mm), b, between the top of the cooktop and any cabinet above it. The overhead cabinet depth, if unprotected, must not exceed 13 inches (33 cm). The minimum distance of combustible surfaces located above and to the sides of the cooktop, c, is 18" (457 mm). If the cabinet manufacturer recommends a different distance, follow that manufacturers recommendation. When installing the cooktop under a venting hood, always observe the minimum distances recommended by the hood manufacturer. Keep this instruction book in a safe place and pass it on to any future owner. 5 Cooktop dimensions KM 404 a Support brackets b Building in height plus 1/8" (3 mm) for the fixing screws * Please allow an additional 31/2" (90 mm) depth across the rear of the cooktop for clearance of the gas regulator (see "Gas connection" for illustration). 6 Cooktop dimensions KM 406 a Support bracket b Building in height plus 1/8" (3 mm) for the fixing screws * Please allow an additional 31/2" (90 mm) depth across the rear of the cooktop for clearance of the gas regulator (see "Gas connection" for illustration). 7 Countertop cut-out Installing one or multiple appliances: Cut out the countertop using the dimensions listed in the following table. Number of cooktops 1 2 3 4 All Miele combisets have the same length and width. Make sure that there is enough room under the countertop to allow for the depth of the various appliances. Remember to allow clearance for the gas regulator and gas pipe that must be connected to the appliance. It should be plugged directly into a properly grounded outlet. Do not cut or remove the grounding prong from the plug. If the plug does not fit the outlet, have the proper outlet installed by a licensed electrician. or - Canadian Electrical Code Part I for Canada (CSA Standard C 22. 1). , WARNING - Disconnect the appliance from the main power supply before installation or service. To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. Power supply The automatic ignition requires that the cooktop be connected to a 120 VAC, 60 Hz power supply. The supply line should be protected by a 15 A breaker. Actual power consumption (during ignition only) is 25 W. (1. 2 m) long power cord that is ready for connection to the appropriate outlet. Please place the power outlet so that it is accessible after the appliance has been installed in the countertop. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be held responsible for damages caused by the lack, or inadequacy, of an effective grounding system. [. . . ] The minimum supply pressure to get the required gas input is 6" w. c. for LP gas. 14 Gas connection Gas pressure regulator A pressure regulator that is convertible from natural to LP gas (Propane) or vice versa is included with the appliance. The included regulator corresponds with the gas type of the cooktop. The adjusted pressure is: natural gas - 4" w. c. [. . . ]