User manual RYOBI RD2011 VUE GLOBALE

[. . . ] The manufacturer cannot be held responsible for damage caused by an incorrect installation or connection. This appliance is only intended for residential cooking. The manufacturer can not be held responsible for damage or injury caused by improper use or for uses other than those for To guarantee the electrical safety of this appliance, continuity must which this appliance is exist between the appliance and an efintended. fective grounding system. It is imperative that this basic safety requirement is met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. [. . . ] Build-up pressure may cause the container to burst and result in injury. At higher settings, be cautious of splattering grease or boiling over liquids, which may produce smoke. IMPORTANT SAFETY INSTRUCTIONS Before removing pots and pans, be sure to turn off the burners. Do not store items on the appliance when not in use. Items could melt or catch fire from residual heat or if the cooktop is turned on inadvertently. Never leave the cooktop unattended when cooking with oil or fat. Always heat oil slowly, monitoring it as it heats. Smother any fire or flame, or use a dry chemical or foam-type extinguisher. When frying food, make sure that the food is as dry as possible before placing it in the oil. Moisture can cause hot oil to splatter and boil over. Do not flambé under an exhaust hood. Flames could be drawn up into the hood by the suction or the grease filters may ignite. Before discarding an old appliance, remove the power cord to prevent hazards. SAVE THESE INSTRUCTIONS AND REVIEW THEM PERIODICALLY 8 Help protect our environment Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Disposal of an old appliance Old appliances contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials. Before discarding an old appliance, disconnect it from the gas and electrical supply and cut off the power cord to prevent it from becoming a hazard. 9 Guide to the cooktop KM 421 abcd Single burners Control knobs for burners e rear left f rear right g front left h front right i Area with 4 operating-/ residual heat indicator lights KM 421 diameter inches (cm) Watts rear left a 5 3/4" (14. 5) 1200 rear right b 7" (18) 1800 front left c 7" (18) 1800 front right d 5 3/4" (14. 5) 1200 10 Guide to the cooktop KM 424 a Single burner b Extended burner cd Variable burner e Indicator light shows variable burner or extended burner is activated f Control knobs (position corresponding with the burner) g Area with 4 operating-/ residual heat indicator lights KM 424 diameter inches (cm) extended Watts extended 1200 rear left a 5 3/4" (14. 5) rear right b 6 3/4" (17) 6 3/4" x 10 1/2" (17 x 26. 5) 1500 2400 front right c 4 3/ 4" (12) 7" (18) 700 1800 front left d 5 3/4" (14. 5) 8 1/4" (21) 1100 2400 11 Guide to the cooktop KM 427 ac Single burners b Extended burner de Variable burners f Indicator light shows variable burner or extended burner is activated g Area with 5 operating-/ residual heat indicator lights h Control knobs (position corresponding with the burner) KM 427 diameter inches (cm) extended Watts extended 1200 rear left a 5 3/4" (14. 5) rear middle b 6 3 / 4" (17) 6 3/4" x 10 1/2" (17 x 26. 5) 1500 2500 1200 rear right c 5 3/4" (14. 5) front right d 4 3/ 4" (12) 7" (18) 700 1800 front left e 5 3/4" (14. 5) 9" (23) 1100 2500 12 Before using for the first time Clean the cooktop Before using for the first time, clean the cooktop with a damp cloth and then dry with a soft cloth. Heat the cooktop The metal components of the cooktop have a protective coating which may give off a slight odor the first time the appliance is heated. The smell will dissipate after a short time and does not indicate a faulty connection or appliance defect. 13 Use Turning on and off Operating a variable / extended burner If a burner has the symbol n next to the control knob, you can switch on an additional outer or extended heating circle. To turn on a burner push down and turn the control knob: ­ clockwise to the desired setting turn on one heating circle, ­ counter-clockwise to the desired setting to turn on both heating circles. If both heating circles are turned on an indicator light will come on left of the control knob. To adjust the setting, turn the knob without pressing down. The burner is turned off by turning the control knob clockwise or counter-clockwise to "0". Operating a single burner A burner without the symbol n next to the control knob is turned on by pushing the control knob down and turning it clockwise or counter-clockwise to the desired setting. [. . . ] Follow the manufacturer's instructions on the packaging. Make sure that no cleaner residue remains on the ceramic surface by carefully wiping the cooktop with a damp cloth. Cleaner residues could damage the cooktop when heated. After cleaning, thoroughly dry the ceramic surface with a soft cloth to prevent a build up of limescale deposits. [. . . ]