User manual RYOBI RD330 VUE GLOBALE

[. . . ] The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion or dissolving. The cooktop should only be installed as shown in the illustrations, while maintaining the required safety distances shown. Do not install the cooktop between two tall cabinets, this is a fire hazard. a A minimum distance of 2" (50 mm) from the cooktop to the rear wall and a side wall or cabinet must be maintained for safety. [. . . ] a A minimum distance of 2" (50 mm) from the cooktop to the rear wall and a side wall or cabinet must be maintained for safety. To eliminate the risk of burns or fire by reaching over heated surfaces, cabinet storage space above the cooktop should be avoided. If cabinet storage is necessary, the risk can be reduced by installing a venting hood to project horizontally a minimum of 5" (127 mm) beyond the bottom of the cabinets. recommended 2" 50mm b not recommended not allowed 3 IMPORTANT SAFETY INSTRUCTIONS This equipment has not been designed for maritime use or for use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for an installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. Because of the heat radiated from this type of appliance we do not recommend installing it over a drawer. It should be installed in a cabinet base unit with a dummy drawer front and an additional protective barrier beneath the unit. If there is a drawer directly underneath the cooktop, do not store aerosols, combustible liquids or easily flammable materials in it. If cutlery inserts are placed in the drawer, they must be heat resistant. ^ Seal the cut surfaces with a suitable heat resistant sealant to avoid swelling caused by moisture. If, during installation, the seal around the frame does not sit flush with the countertop or the corners, the corner radius max. R4 (3/8") can be carefully filed down to fit. 3/8" drill bit. 7 Installation Installing the spring clips (75m m) 3 " Granite countertops b ^ Fix the supplied spring clips, a, at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 3. 5 x 25 mm screws supplied. For granite countertops, the spring clips, b, must be placed in position and secured with double-sided tape. In addition, coat the edges of the spring clips with silicone sealant. The screws are not needed for granite countertops. 8 Installation Installing the cooktop ^ Feed the power cord down through the cut-out and connect the appliance to the power supply. ^ Position the cooktop on the spring clips, a. ^ Then with a hand on each side of the cooktop press down on the edges evenly until it clicks into position. When doing so make sure that the cooktop seal sits tightly on the countertop to ensure a correct seal is provided. The cooktop can now only be removed with a special tool. The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. [. . . ] The cooktop can now only be removed with a special tool. The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or appliance could be damaged if the cooktop needs to be removed for maintenance or service. 9 Electrical connection Important All electrical work should be by a qualified electrician in accordance with local and national codes. To reduce the risk of electric shock, disconnect the power supply by tripping the circuit breaker or removing the fuse to the unit before installation or service. [. . . ]