User manual RYOBI RES1000 SCHEMA ELECTRIC

[. . . ] When using your appliance follow basic safety precautions including the following: ~ To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. A small gap will be visible between cooktop and countertop for the first days after installation. [. . . ] Be sure to clean the cooktop after each use. Each time this residue is allowed to melt it becomes harder to remove and may mar the appearance of the cooktop. Let the cooktop cool before cleaning. Cast iron, glass or stoneware should not be used because they have poor heat transfer and may scratch the cooktop surface. 19 Timer The cooktop has a timer which can be used to time activities in the kitchen and/or automatically turn off the burners. Both functions can be used simultaneously. A time between 1 and 99 minutes can be set. The time can be decreased or increased with the - or + touch control. To set the display back to 00 press and + at the same time. If multiple times are programmed, the time which elapses first is displayed. If this time is allocated to a burner, the respective indicator will flash. Setting the timer The timer can be set with the cooktop either on or off. The timer can be set from 1 to 99 minutes. To set the timer when the automatic turn off is programmed for one or more burners: Press the sensor m until all indicators of the programmed burners light steadily and the display shows 00. To deactivate the Child Safety Lock ^ Press and hold the $ Child Safety Lock control until the indicator goes out. In the case of a power failure the Child Safety Lock will be deactivated. 22 Safety features Stop and Go Your appliance has a Stop and Go feature which, when activated, reduces the power of all burners that have been switched on. If you then deactivate the feature, the burners will automatically return to the previous level. If the feature is not deactivated, the cooktop will turn off after 1 hour. If you wish to use this feature, you will need to alter the factory setting (see "Programming - P1"). To activate Stop and Go: ^ Press and hold the sensor $ until you hear two consecutive beeps. Be careful not to continue touching the $ sensor for too long, as this will activate the safety lock. The Child Safety Lock indicator will flash. The power for the activated burner(s) will reduce to level 1, and 1 will appear in the respective display. When activating "Stop and Go": ­ the countdown of the programmed time for the automatic switch-off function will be interrupted. When deactivating "Stop and Go", the countdown will continue, ­ the timer will continue without interruption. To deactivate Stop and Go: ^ Press and hold the $ control until the indicator goes out. [. . . ] The materials used must be heat resistant. If during installation the seal around the frame does not sit flush with the countertop in the corners, the corner radius, maximum 3/16" (4 mm), can be carefully filed down to fit. 36 Installation Installing the spring clips Wood or solid surface countertops Granite countertops ^ Fix the supplied spring clips at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1/8" x 1" (3. 5 x 25 mm) screws supplied. ^ For granite countertops, the spring clips must be placed in position and secured with strong, double-sided adhesive tape. ^ In addition, coat the edges of the spring clips with silicone sealant. The screws are not needed for granite countertops. 37 Installation Installing the cooktop ^ Feed the power cord down through the cut-out and connect the appliance to the power supply. ^ Position the cooktop on the spring clips, a. [. . . ]