User manual RYOBI RESV-2010

[. . . ] The nameplate on this appliance indicates what voltage it uses. Never connect the appliance to an AC voltage that differs from this voltage. The appliance should be supplied via a residual current device (RCD) with a tripping current of not more than 30mA. Doing so may cause a fire or explosion and/or damage to the appliance. [. . . ] To avoid severe damage to the impeller, do not vacuum metal, broken glass, etc. Do not overreach or use the unit from unstable surfaces such as ladders, trees, steep slopes, rooftops, etc. Do not vacuum warm ash from fireplaces, barbecue pits, etc. Do not vacuum discarded cigars or cigarettes unless the cinders are completely cool. Do not put part of your body such as hands and fingers in the vacuum opening or exhaust opening, etc. This appliance is equipped with an on/off switch (1). To turn the unit on, slide the switch to forward (direction A). And to turn the unit off, slide the switch to backward (direction B). The air speed of this appliance can be adjusted. Turning the speed adjustment volume (2) in the direction "C" increases the air speed, and turning it in the direction "D" decreases the air speed. Align the protruding part (7) of the nozzle with the groove (8) on the main body of the unit and insert the nozzle (4) into the main body of the unit. Do not connect the power supply before attaching the nozzle. Disconnect the appliance from the power supply when it is not in use and before servicing. Keep all nuts, bolts and screws tight to be sure the appliance is in safe working condition. Keep your appliance in good working condition. Only an AUTHORIZED SERVICE CENTER or other QUALIFIED SERVICE ORGANIZATION should perform maintenance procedures that are not described in this manual. Use only original replacement parts approved by RYOBI when servicing this appliance. The use of non-standard parts, or other accessories or attachments not designed for this appliance, could result in serious injury to the user and/or damage to the appliance. STORE THE APPLIANCE INDOORS - When not in use, the appliance should be stored indoors in a dry and high place - out of the reach of children. Keep the appliance away from harmful substances such as solvents and fertilizers. It is possible to adjust the nozzle length by first loosening the knob (3) and then sliding the nozzle (4) forwards or backwards. When the nozzle is at a length that is easy to use, fix it in place by tightening the knob. [. . . ] With eye protection on, turn the dust bag inside out after initial emptying and vigorously shake out the dust and debris. 18, 19 and 20 and sweep from side to side with the nozzle a few inches above the ground or floor. Move the appliance slowly, while accumulating a pile of debris. Use the appliance as a blower for trees, shrubs, flower beds and hard to clean areas. [. . . ]