User manual RYOBI RGBV3100

[. . . ] Thank you for buying this quality product. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. Make sure this manual is carefully read and understood before starting or operating this equipment. Back Cover CONTENTS OF CARTON This unit includes the following: · The purpose of safety symbols is to attract your attention to possible dangers. [. . . ] Failure to do so can result in serious injury to the operator and/or bystanders. ⷠWEAR EYE AND HEARING PROTECTION WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. Wear eye protection and ear protection when operating this unit. ⷠKEEP BYSTANDERS AWAY WARNING: Keep all bystanders, especially children and pets, at least 15 meters (50 ft. UNLEADED FUEL Always use clean, fresh unleaded fuel. Never point the blower at yourself or others. Do not operate unit without proper attachments and guards in place. WARNING: The operation of any power tool can cause foreign objects to be thrown into your eyes. Before commencing power tool operation, always wear safety glasses or goggles, and a full face shield when needed. These parts get extremely hot from operation. When turned off they remain hot for a short time. BLOWERS AND BLOWER/VACUUMS ­ ROTATING IMPELLER BLADES CAN CAUSE SEVERE INJURY WARNING: Stop the engine and allow the impeller to stop before installing or changing tubes or bag, or before cleaning or performing any maintenance. ATTACHING AND REMOVING THE BLOWER/ VACUUM TUBE Attaching NOTE: The Blower/Vacuum Tube comes unassembled on this unit. Installation is required to provide safe and easy use for the operator. Remove the screws and nuts provided from the hardware pack. Insert the blower/vacuum tube all the way into the opening on the motor housing until the holes in the tabs on the blower/vacuum tube align with the screw holes in the housing (Fig. Insert the 2 (two) 8-32 x 3/4" slotted T20 Torx screws into the right side of the motor housing and the 2 (two) nuts into the left side of the motor housing (Fig. Install the 2 (two) remaining self-tapping 8-16 x 3/4" slotted T20 Torx screws into the holes on either side of the housing (Fig. Tighten until snug, do not over-tighten. Stop the engine and allow the impeller to stop before attaching or removing tubes. Push the tube until the latching tabs on both sides click into place, securing the bag on the unit (Fig. Press the latching tabs on both sides of the vacuum bag tube and pull the vacuum bag from the unit (Fig. [. . . ] To reduce the risk of hearing loss associated with sound level(s), the use of hearing protection is required. Watch out for children, pets, open windows, or freshly washed cars, and blow debris away. After using blowers and other equipment, CLEAN UP!NOTE: Never use the unit with the lever in the halfway position. [. . . ]