User manual RYOBI RLH1100MKII-RLH1100MK2

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite dust or fumes. Children, visitors and pets should be kept a safe distance from the work area. Avoid wearing loose clothing, jewellery or anything that could get caught in moving parts. [. . . ] Use only saw blades for which the maximum possible speed is not less than the maximum spindle speed of the tool and the material to be cut. Never stand or have any parts of your body in line with the path of the saw blade. Keep your hands out of the line the saw blade. Move the rip fence out of the way when cross cutting. Feed the work into the blade or cutter AGAINST the direction of rotation only. Never use the fence as a cut-off gauge when crosscutting. Never attempt to free a stalled blade without first turning the saw OFF. Turn off the power switch immediately to prevent motor damage. When transporting the machine use only transportation devices and never use guards for handling or transportation. During transportation the upper part of the saw blade should be covered. Use the extension table for supporting long workpieces during cutting operation. Align the three holes of both left/right extension tables (4&5) with the three holes in the two wings of mind table (Fig. Bolts and spring washers to lock the two end holes & one M6x 16 bolt to fix the middle hole. Align the two holes of rear extension table (18) and with two M6x 12 screw, flat washer, spring washer and M6 nut secure the rear extension table(18) to the main table (Fig. To mount support bars (23) to Extension tables (4, 5 &18) and body (1), use M6 screw, flat washer, spring washer and M6 nuts. Ensure the extension tables are in line and surfaces are flush with the main table. Fully tighten blots when all assembly is complete, if fitting the machine to the leg stand assemble and fit this before tightening the blots. Loosen the rip fence lock knobs(24) on the sliding block(19), then slide the fence(6) onto the bolt heads and tighten the rip fence lock knobs(24) (Fig. 8) To lock the rip fence(6), slide the rip fence assembly until the indicator is pointing to the desired setting. Then press rip fence lock handle (3) downwards (Fig. Do not use saw blades which are damaged or deformed. Take care that the selection of the saw blade depends on the material to be cut. [. . . ] Follow the same procedures as you would for crosscutting. Bevel crosscutting is similar to crosscutting except that the wood is cut at an angle other than the 90° with the flat side of the wood or table (fig. The cut is made at an angle other than 90° to both the edge and the flat side of the wood. Adjust the mitre gauge (9) and the blade (15) to the desired angle and ensure the mitre gauge (9) is locked by using the mitre gauge lock(10). [. . . ]