User manual RYOBI RMS-1221

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Placez la scie sur une surface de niveau et plane, suffisamment spacieuce pour permettre la manipulation et un appui correct de la pièce usinée. Faites glisser l'extrémité rainurée du support de fixation du protège-lame inférieur sous la tête de vis et faites pivoter le support de fixation du protège-lame inférieur jusqu'à ce que le trou du support s'aligne avec le trou fileté du protège-lame supérieur. This user's manual describes safety and international symbols and pictographs that may appear on this product. [. . . ] Saw Blade Path The area over, under, behind, or in front of the blade. When it applies to the workpiece, this consists of the area which will be, or has been, cut by the blade. Set The distance from which the tip of the saw blade tooth is bent (or set) outwards from the face of the blade. Usually due to the fact that the workpiece is not against the fence, has hit the blade or has inadvertently been placed in contact with the blade rather than the presence of a saw mark in the workpiece. Through Sawing Any cutting operation where the blade extends completely through the thickness of the workpiece. The surfaces of a workpiece are commonly referred to as faces, ends, and edges. No-Hands Zone The area between the cutting lines on the left and right sides of the mitre table base. This zone is identified by "no-hands" labels placed inside the cutting lines on the mitre table base. The operator's hands must stay clear of this area during all sawing operations. CAUTION In order to avoid motor damage, sawdust should be frequently vacuumed out to keep it from blocking normal motor ventilation. If the motor does not start, release the trigger switch immediately. Check that nothing is preventing the saw blade from turning. If the blade is not blocked, try to start the motor again. If the motor stalls suddenly while you are cutting wood, release the trigger switch, unplug the tool, and move the workpiece away from the blade. Then restart the motor and finish the cut. Fuses may "blow" and circuit breakers may trip frequently if: a. THE MOTOR IS OVERLOADED-Overloading can occur if you feed in the workpiece too rapidly, or if there are too many saw accelerations / releases in a short period of time. Voltages within ± 10% of the voltage stated on the dataplate can handle normal loads. For heavy loads, however, the voltage may be insufficient for the motor to operate (because of too small a wire in the supply circuit or an overly long supply circuit wire). Always check the connections, the load and the supply circuit whenever the motor does not run properly. Numerous motor problems are caused by loose or incorrect connections, overload, insufficient voltage (due to small size wire in the supply circuit) or overly long supply circuit cables. Always check the connections, the load and the supply circuit whenever the motor doesn't run properly. [. . . ] Lower the blade onto the lower table, making sure that it does not come into contact with the base or table structure. WARNING: Do not try to cut short pieces. You cannot properly support the workpiece and keep the hand which holds down the workpiece at the required distance from the blade. Before cutting a workpiece, check to make sure it is not bowed. [. . . ]