User manual RYOBI RPP755E

[. . . ] Subject to technical modification / Sous réserve de modifications techniques / Technische Änderungen vorbehalten / Bajo reserva de modificaciones técnicas / Con riserva di eventuali modifiche tecniche / Technische wijzigingen voorbehouden / Com reserva de modificações técnicas / Med forbehold for tekniske ændringer / Med förbehåll för tekniska ändringar / WARNING When using the product, the safety rules must be followed. For your own safety and that of bystanders, you must read and fully understand these instructions before operating the product. Please keep these instructions safe for later use. PERSONAL SAFETY Stay alert, watch what you are doing and use common sense when operating a power tool. [. . . ] The following items should be used when operating your product: Safety helmet – should comply with EN 397 and be CE marked Hearing protection – should comply with EN 352-1 and be CE marked Eye and face protection – should be CE marked and comply with EN 166 (for safety glasses) or EN 1731 (for mesh visors) Gloves – should comply with EN 381-7 and be CE marked Footwear – should comply with EN 20345 and be CE marked OPERATION – PRUNING Study the condition of the tree and branches before starting work. If there are signs of damage, rot or decay, do not attempt to prune yourself. damaged or rotten branches are highly unstable. Seek the services of a professional tree surgeon. Never stand under the branch to be pruned. Pruned branches do not always fall cleanly to the ground. They are easily caught and deflected by other foliage. Ensure that a safety zone at least twice the length of the branch to be cut is available and maintained during your pruning. If this is not possible, seek the services of a professional tree surgeon. Ensure that the falling branch is not a danger to yourself, bystanders or property including utility cables. Never operate the tool with the pole at an angle of greater than 60° from the horizontal. Never operate the pruner with the cutting means closer than 10 m from overhead power lines. Do not force the tool, let the chain do the work at its own speed. Do not try to cut the branch too close to the tree trunk. Leave about 15 cm from the trunk to the cut. Make this cut approximately one third of the way through the branch. Then make a second cut from above the branch using the bottom of the saw bar to Consider pruning large branches in manageable sections rather than as a whole. Never try to restart a previous cut with the chain and bar in the earlier cut. This will WARNING The saw chain is very sharp. To prevent personal or removing the chain scabbard, and always wear protective gloves when performing maintenance to the chain. wARNING Improper chain maintenance increases the potential of kickback. Failure to replace or repair damaged chain can Switch off and disconnect from the mains before conducting any maintenance or cleaning work. [. . . ] The end user needs to register his/her newly-acquired tools online within 8 days from the date of purchase. The end user may register for the extended warranty in his country of residence if listed on the online registration form where this option is valid. Furthermore, end users must give their consent to the storage of the data which are required to enter online and they have to which is sent out by e-mail, and the original invoice showing the date of purchase will serve as proof of the extended warranty. Your statutory rights remain unaffected. [. . . ]