User manual RYOBI RPW120X

[. . . ] RPW120X Electric Pressure Washer OPERATOR'S MANUAL (Original Instructions) WARNING! To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Thank you for your purchase. RPW120X manual. indd A1 09-12-15 9:22 ENGLISH(Original Instructions) INTENDED USE The cleaner is intended only for the cleaning of vehicles, boats, buildings, etc, by the removal of stubborn dirt using clean water and chemical detergents. For domestic use only, not for professional use, and only for operation at temperatures above 0° C . WARNING: High pressure jets can be dangerous if subject to misuse. [. . . ] Lift the machine and slide the axle into the wheel mounting hole in the machine base as shown. Push the hitch pin into the hole on the end of the axle to secure the wheel assembly. 6 ATTACHING THE HANDLE ASSEMBLY See Figure 4. Line up the handle assembly with the holes. Depress the button on the handle assembly and insert into the holes on the pressure washer. Press down on the handle assembly until the button on the handle clicks into place. Lower both collars on the handle and rotate clockwise until secure. Push the two ends of the gun/lance together so that the holes inside each end are aligned. Lower the locking collar and rotate counter clockwise to tighten securely. CONNECTING HIGH PRESSURE HOSE TO GUN See Figure 6. Insert the connector on the end of the high pressure hose collar into the gun. Slide the collar over the coupler turning the collar clockwise to tighten securely. Pull on the hose to be certain it is properly secured. CONNECTING THE HIGH PRESSURE HOSE TO THE PUMP See Figure 7. Insert the connector on the end of the high pressure hose collar into the pump outlet coupler. Slide the collar over the coupler turning the collar clockwise to tighten securely. Pull on the hose to be certain it is properly secured. The TSS will activate when user releases the spray gun trigger and will automatically shut the unit off. CONNECTING THE GARDEN HOSE TO THE PRESSURE WASHER See Figure 7. Before connecting the garden hose to the pressure washer: Run water through the garden hose for 30 seconds to clean any debris from the hose. Inspect the filter screen in the end of the pressure washer intake. If the filter is damaged, do not use the machine until the screen has been replaced. RPW120X manual. indd Sec2:6 09-12-15 9:22 ENGLISH(Original Instructions) If the filter is dirty, clean it before connecting the garden hose to the machine. [. . . ] This warranty does not cover transportation cost or consumable items such as fuses and batteries. This limited warranty is void if the product's original identification (trade mark, serial number, etc. ) markings have been defaced, altered or removed or if product is not purchased from an authorised reseller or if product is sold AS IS and / or WITH ALL FAULTS. Where permitted, the provisions of this limited warranty are in lieu of any other written warranty, whether express or implied, written or oral, including any warranty of MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL WE BE LIABLE FOR SPECIAL, INCIDENTAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES. [. . . ]