User manual RYOBI RRR722

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite dust or fumes. Children, visitors and pets should be kept a safe distance from the work area. Avoid wearing loose clothing, jewellery or anything that could get caught in moving parts. [. . . ] Use only saw blades for which the maximum possible speed is not less than the maximum spindle speed of the tool and the material to be cut. Never stand or have any parts of your body in line with the path of the saw blade. Keep your hands out of the line the saw blade. Move the rip fence out of the way when cross cutting. Feed the work into the blade or cutter AGAINST the direction of rotation only. Never use the fence as a cut-off gauge when crosscutting. Never attempt to free a stalled blade without first turning the saw OFF. Turn off the power switch immediately to prevent motor damage. When transporting the machine use only transportation devices and never use guards for handling or transportation. During transportation the upper part of the saw blade should be covered. Use the extension table for supporting long workpieces during cutting operation. Take care that the selection of the saw blade depends on the material to be cut. The Blade(15) has been adjusted at the factory, use a square to check that the blade is o at a 90 angle to the table (Fig. 8) If adjustment is needed turn the tilting lock nut (while holding the adjustment in position) to fix the adjustment. Then loosen the indicator fixing screw, set the indicator of the scale (12) on the "0o" marked then tighten the fixing screw (Fig. Turn the adjustment nut so that the blade is on the 45o position and then tighten the lock nut. When the machine is connected with the power supply, the live indicator (26) will glow. If not, please check if the power plug is well connected Should the supply be interrupted the switch will automatically default to the "OFF" position preventing a dangerous unexpected startup of the machine when the supply is restored. WARNING: Before turning the machine ON, make sure he blade guard is correctly installed and operating properly. Your table saw features an overload reset button(14). In the event that your saw turns off during operation, turn the saw off and allow the motor to cool down for approximately 3 minutes. Push the reset button(14) and attempt to turn the saw on again. [. . . ] position the fence by to the desired width of the rip and lock it in place. Before starting to rip, be sure the rip fence is parallel to the saw blade (15) and the riving knife is properly aligned with the saw blade. When ripping long boards or large panels, always use a work support. Hold the piece against the fence (6) and feed it through the blade (15) with a smooth, steady pressure. [. . . ]