User manual RYOBI RWH1100-RWH-1100MKII

[. . . ] Match bit to screw size to prevent damage to the screw head. Never cover vents since they must always be open for proper motor cooling. Do not use power tools in damp or wet locations. Do not use power tools in places where there is a risk of fire or electric shock. [. . . ] Avoid body contact with earthed or grounded surfaces (e. Do not let visitors touch the tool or extension cord. All visitors should be kept away from the work area. When not it use, the tool should be stored in a dry, high or locked-up place, out of children's reach. It will do the job better and safer when used at the rate for which it was intended. Do not force small tools to do the job of a heavy duty tool. Only use this tool for the purposes for which is was designed. Do not wear loose clothing or jewellery, they can get caught in moving parts. Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. Never carry the tool by the cord or yank it to disconnect it from the power socket. Turn the adjusting sleeve to the appropriate bit holder depth or to any desired depth. test the driver by screwing in a fastener in scrap material to determine whether the screwing depth is correctly adjusted. Further adjustment may be necessary to increase or decrease the screwing depth. Noise (sound pressure level) in the workplace can exceed 85 dB (A). In this case, sound insulation and hearing protection measures must be taken by the operator. This tool is started and stopped by depressing and releasing the trigger (5). If you want to set a constant speed for continuous operation, press the lock-on button (6) while the trigger is depressed. Depress the trigger again to release the lock. to reverse the direction of rotation of the bit , stop the driver by releasing the trigger and push the reversing switch (4) to the right or left. When the reversing switch is set to the LEFT the screw driver will turn clockwise (seen from the handle end of the driver). When the reversing switch is set to the RIGHT the screw driver will turn anti-clockwise. [. . . ] When the reversing switch is set to the LEFT the screw driver will turn clockwise (seen from the handle end of the driver). When the reversing switch is set to the RIGHT the screw driver will turn anti-clockwise. To drive a screw, put the screwdriver bit in the screw head and align the driver in the desired position against the work surface. Depress the trigger and once the motor is running, push the tool forward to start screwing or unscrewing. [. . . ]