User manual RYOBI RWS1400

[. . . ] Never hold piece being cut in your hands or across your leg. secure the workpiece to a stable platform. It is important to support the work properly to minimize body exposure, blade binding, or loss of control. Hold the power tool by insulated gripping surfaces only, when performing an operation where the cutting tool may contact hidden wiring or its own cord. [. . . ] Always observe that the lower guard is covering the KICKBACK CAUSES AND RELATED WARNINGS: ?kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw to lift up and out of the workpiece toward the operator; when the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator; if the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back toward the operator. ? ? ? ? Kickback is the result of saw misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below. Maintain a firm grip with both hands on the saw ? 1 English blade before placing saw down on bench or floor. An unprotected, coasting blade will cause the saw to walk backwards, cutting whatever is in its path. Be aware of the time it takes for the blade to stop after switch is released. Do not use blades of larger or smaller diameter than recommended. Use of any other parts may create a hazard or cause product damage. Be sure to disconnect the tool from the power supply before attaching or removing the saw blade. Clean the tool and guarding system with clean cloths, or blow it clean with compressed air. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to various types of commercial solvents and may be damaged by their use. use clean cloths to remove dirt , carbon dust , etc. Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc. They contain chemicals that can damage, weaken or destroy plastic. Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. if operation is dusty , also wear a dust mask. If the power supply cord is damaged, it must be replaced only by the manufacturer or by an authorized service center to avoid risk. For greater safety and reliability, all repairs should be performed by an Authorised Ryobi Service Centre. Do not stare into beam during operation. Do not project the laser beam directly into the eyes of others. Do not place the laser in a position that may cause anyone to stare into the laser beam intentionally or unintentionally. [. . . ] AUTHORISED SERVICE CENTRE To find an authorised service centre near you, visit ryobitools. I hndelse av felaktig funktion medan garantin r i kraft skall produkten sndas UTAN ATT DEMONTERAS tillsammans med inkpsbeviset till leverantren eller till nrmaste servicecenter som auktoriserats av Ryobi. EN WARNING IT AVVERTENZE The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. [. . . ]