User manual RYOBI RYAN-264-1

[. . . ] Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. Never carry the tool by the cord or yank it to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges. [. . . ] Do not use the tool if the switch does not turn it on and off. Warning The use of any accessory or attachment other than those recommended in this user's manual may present a risk of personal injury. This tool complies with the relevant safety rules for electric tools. Wherever there are facilities for fitting a dust extraction system, make sure it is properly connected and correctly used. Important It is imperative to follow all national safety regulations concerning installation, operation and maintenance of the tool. Noise level (or sound pressure level) in the work area can exceed 85 dB(A). In this case, operators should take appropriate measures to ensure sound insulation and wear ear protectors. Important To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Before you use your tool, read these instructions carefully and make sure that you understand them thoroughly. Make sure that the supply voltage (Volts) used corresponds to the voltage marked on the tool's rating plate. When using cable drums, run all the cable off the drum. ERH-650V Voltage Power consumption No Load speed Maximum drilling capacity: - steel - concrete / stone Tool attachment Weight 230V 50 Hz AC only 650W 0 - 1100 min-1 13 mm 20 mm SDS-plus 3. To limit the maximum speed of the drill, rotate the dial on the front of the trigger until the desired setting is achieved. Lock-on button If you want to keep your hammer drill operating at a constant speed, press the lock-on button (3) while pressing the variable switch. To unlock this function, briefly press the variable switch (2) then release it. Case Hammer drill Depth stop Auxiliary handle For reasons of safety, only use the hammer drill when it is fitted with the auxiliary handle. To loosen the auxiliary handle, rotate the handle anticlockwise until the handle assy is free to move. Position the handle as required then lock securely by rotating the handle clockwise until it is tight. The depth of the hole drilled will be equal to the distance between the end of the drill bit and the front end of the depth stop. Examine the place where the tool is to be used for hidden electrical cables, gas, and water pipes using a pipe finding device. Before you plug in your tool, make sure that the supply voltage used corresponds to that indicated on the rating plate. Your hammer drill is equipped with a hammer stop facility for smooth drilling. [. . . ] Unplug the hammer drill before making any adjustment, servicing or cleaning the tool. Never use caustic agents to clean the plastic parts. At the end of your work, to prevent dust deposits you should use compressed air (max. This tool features a live tool indicator (7) which illuminates as soon as the tool is connected to the supply. [. . . ]