User manual RYOBI RYAN-B280-ENGINE

[. . . ] Use only a water-jet-proof extension lead approved for outdoor use (H07RN-F). Secure extension lead by hanging it in the Fig. Pull-relief ( Before using, inspect tool, extension lead and plug. Have damaged parts replaced or repaired only by a specialist. [. . . ] inspect cutters regularly for damage and , if necessary , repair them. Familiarise yourself with your surroundings and be on the alert for possible hazards which you may not notice because of the noise from the machine. never grasp the tool by the cutter bar. During transport or storage always cover the cutting equipment with the cutter guard. observe general safety procedures for handling electric tools. Always ensure the guard is fitted when using the tool. Never attempt to use an incomplete machine or one fitted with an unauthorised modification. Carefully guide the cable in order to avoid accidentally cutting it. A good way to control the cable is by putting it over your shoulder. Connect the tool plug to an approved extension lead and protect the plug connecFig. For your safety, this tool is equipped with a double switching system. The manufacturer and/or the supplier will not be responsible for the damages that will arise. Never use an equipment if the switch doesn't control any more the switch-ON and the switch-OFF of the unit. Wearing a head protection is necessary when there is the possibility of objects falling. To avoid accidents, do not wear jewellery or loose clothing that could be caught up by moving parts. For outdoor use, it is recommanded to wear protective footwear. When dust, splinters or shavings are a problem while working, please wear protective eyewear and if necessary a protective mask. Be sure you always have sure footing, especially when working on ladders and scaffolding. Keep electric tools away from humidity and rain. When working outdoors, only use approved tools and extension cables marked for outdoor use. Do not use the equipment areas where danger of explosion exists. When passing this device over to a third person, these instructions must be handed out too. [. . . ] Replace or make replace any damaged pieces. Connect the power lead to the mains only with the tool turned off. Always turn on the tool before setting it against the piece you are working on. Keep your workplace tidy: untidiness can cause accidents! [. . . ]