User manual RYOBI SA60

[. . . ] OPERATOR'S MANUAL CORDLESS DRILL-DRIVER MODEL NOS. SA60 / SA720 MODEL SA60 MODEL SA720 20 This new drill has been engineered and manufactured to our Ryobi's high standard for dependability, ease of operation, and operator safety. When properly cared for, the drill will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Thank you for buying a Ryobi product. SAVE THIS MANUAL FOR FUTURE REFERENCE 20 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Rotate the chuck body with your other hand. The arrows on the chuck indicate which direction to rotate the chuck body in order to LOCK (tighten) or UNLOCK (release) the drill bit. DRILL BIT 20 LOCK (TIGHTEN) CHUCK COLLAR WARNING: Do not hold the chuck body with one hand and use the power of the drill to tighten chuck jaws on drill bit. Chuck body could slip in your hand or your hand could slip and come in contact with rotating drill bit. This could cause an accident resulting in serious personal injury. RIGHT 5 Fig. 3 Page 10 ADJUSTMENTS INSTALLING BITS See Figures 3 and 4. Lock the switch trigger by placing the direction of rotation selector in center position. Open or close chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws. Insert drill bit straight into chuck the full length of the jaws. Tighten the chuck jaws on the drill bit. To tighten the chuck jaws on drill bit; grasp and hold the collar of the chuck with one hand, while rotating the chuck body with your other hand. Note: Rotate the chuck body in the direction of the arrow marked LOCK to tighten chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws. WRONG 20 Fig. 4 WARNING: Make sure to insert drill bit straight into chuck jaws. Do not insert drill bit into chuck jaws at an angle then tighten, as shown in Figure 4. This could cause drill bit to be thrown from drill, resulting in possible serious personal injury or damage to the chuck. REMOVING BITS See Figure 3. Lock the switch trigger by placing the direction of rotation selector in center position. Loosen the chuck jaws from the drill bit. To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand. NOTE: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws. Remove the drill bit from the chuck jaws. NOTE: Rotate the chuck body in the direction of the arrow marked GRIP to tighten the chuck jaws. DO NOT use a wrench to tighten or loosen the chuck jaws. Page 11 ADJUSTMENTS ADJUSTABLE TORQUE CLUTCH See Figure 5. [. . . ] This product contains nickel-cadmium TM batteries. Local, state or federal laws may N i Cd prohibit disposal of nickel-cadmium 00 . Consult your local waste authority for information regarding available recycling and/or disposal options BATTERIES The battery pack for your tool is equipped with nickelcadmium rechargeable batteries. Length of service from each charging will depend on the type of work you are doing. [. . . ]