User manual RYOBI SC163VS

[. . . ] (406 mm) Variable Speed SCROLL SAW Model SC163VS 30 15 0 THANK YOU FOR BUYING A RYOBI SCROLL SAW. Your new Scroll Saw has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. CAUTION: Carefully read through this entire operator's manual before using your new saw. [. . . ] Note: It may be necessary to countersink washers and nuts on the bottom side of mounting board. MOUNTING SCROLL SAW TO WORKBENCH WARNING: To avoid serious personal injury from unexpected tool movement, always securely mount scroll saw to a workbench. If the scroll saw is to be used in a permanent application, we recommend that you secure it in a permanent location such as a workbench. When mounting the saw to a workbench, holes should be drilled through the supporting surface of the workbench. s Each hole in the base of the saw should be bolted securely using machine bolts, washers, and nuts (not included). Bolts should be of sufficient length to accommodate the saw base, washers, nuts, and the thickness of the workbench. Using the saw base as a pattern, locate and mark the holes where the scroll saw is to be mounted. s Drill four holes through the workbench. s Place scroll saw on workbench aligning holes in the saw base with the holes drilled in the workbench. s Insert all four bolts (not included) and tighten securely with washers and nuts (not included). Note: All bolts should be inserted from the top. Install the washers and nuts from the underside of the bench. Supporting surface where scroll saw is mounted should be examined carefully after mounting to insure that no movement during use can result. If any tipping or walking is noted, secure workbench or supporting surface before beginning cutting operations. 30 15 0 C-CLAMP SAW BASE MOUNTING BOARD WORKBENCH Fig. 5 Reducing Noise and Vibration: You may wish to place a foam pad or piece of carpet between the saw base and the workbench to help reduce noise and vibration. If a foam pad or piece of carpet is used, do not overtighten the mounting bolts. Leave some cushion between the padding and the saw base to help absorb the noise and vibration. The size of the padding material should be approximately 24 in. (610 mm x 305 mm x 13 mm). C-CLAMP Page 10 ADJUSTMENTS WARNING: To prevent accidental starting that could cause possible serious personal injury, turn off the saw and unplug the saw from the power source before making any adjustments. SQUARING THE SAW TABLE TO THE BLADE See Figure 7. WARNING: Failure to turn the saw off, remove the switch key, and unplug the saw from the power source could result in accidental starting causing possible serious injury. s Loosen the drop foot lock knob and move drop foot rod all the way up. s Loosen the table lock knob to tilt the saw table until it is approximately perpendicular or at right angle to the blade. s Place a small square on the saw table next to the blade. s Loosen the screw holding the scale indicator. [. . . ] BRUSH CAP ARM BEARING MOTOR BRUSH Fig. 15 Page 17 MAINTENANCE WARNING: To prevent accidental starting that could cause possible serious personal injury, turn off and unplug the saw before maintaining or lubricating your scroll saw. WARNING: Failure to unplug your saw could result in accidental starting causing serious injury. TROUBLESHOOTING WARNING: For your own safety, turn switch OFF and remove plug from power outlet before adjusting or aligning your scroll saw. PROBLEM Motor will not run. CAUSE 1. Problem with ON-OFF switch, power cord, or outlet. SOLUTION 1. Have worn parts replaced before using Scroll Saw again. [. . . ]