User manual RYOBI SINGER-GBC28-SERIALS306057012-AND-GREATER

[. . . ] Avoid body contact with earthed or grounded surfaces. When not in use the tools should be stored in a dry, hight or locked up place, out of reach of children. It will do the job better safer at the rate for which it was intended. n Cluttered areas and benches can cause accident. [. . . ] N During operation we recommend keeping a minimum distance of 10 m between the machine and other people. n Always hold the device with both hands. N Stand in a safe and steady position on both legs. N Never carry the chainsaw by the cable or when it is connected to the mains or with your fingers on the trigger. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. Wear clothing and safety gear suitable for chain saw cutters operations. Always use an extension cable with high insulation characteristics and which meets all current legislation requirements. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Before starting the motor, ensure that the extension cable is clear of the cutting zone. NOTE: make sure that the power tool and accessories in the package are not damaged NOTE: read these operative instructions carefully before attempting to operate the drill N In the event of kickback, the left hand will come into contact With chain brake lever, that incorporates a separate electrical switch to cut out the current to the motor, stopping the chain immediately (`O' position). N To reset after operation of the chain brake, disconnect from power supply and release the brake by pulling the brake lever into the rearward position (`1' position). To operate, ensure both the trigger and the safety lockoff (2) on the side are depressed simultaneously (3). sWITCH OFF To stop the chainsaw , release the trigger. ELECTRIC MOTOR SAFETY SYSTEM This chainsaw has a device that protects the motor by disconnecting it when the effort is too high. N Put the chain (6) on the bar, beginning from the top, ensure cutter teeth are facing direction of chain rotation. N Ensure chain fits around sprocket (15) and check that small end of chain tension lever (16) fits into bottom hole of bar. n Position the carter chain and clamp the nut (12) finger tight. N Adjust chain tension screw (13) so that when lifting the chain, an entire drive link is just visible. The following suggestions deal with the daily maintenance of the chainsaw. If they could not be exhaustive, contact an authorised service centre. [. . . ] n File at an angle of 90° to the bar. N Check the safety depth gauge height every 5 chain sharpenings. N First cut 1/3 of a diameter from below. Next cut from the top using the bottom of the bar. [. . . ]