User manual RYOBI TDS4000

[. . . ] Never start a tool when its rotating component is in contact with the work piece. Never lay a tool down before its moving parts have come to a complete stop. ACCESSORIES: The use of accessories or attachments other than those recommended in this manual might present a hazard. Do not use separate reducing bushings or adapters to adapt large hole grinding wheels. [. . . ] Ensure that sparks resulting from use do not create a hazard e. Do not hit people, or ignite flammable substances. Always use protective safety glasses and ear protectors. Use other personal protective equipment such as gloves, apron and helmet when necessary. Never place the tool on the floor or other surfaces while it is running. grinding wheels continue to rotate after the tool is switched off. Never touch the wheel or place it on the floor or other surfaces while it is rotating. the flange and clamp nut must have same outer diameter. Use the tool only for approved applications. Never use coolants or water or use the tool as a fixed tool. Too great an angle causes concentration of pressure on a small area which may gouge or burn work surface. Use only for the purpose listed below: - Grinding Noise (sound pressure level) in the workplace can exceed 85 dB (A). In this case, sound insulation and hearing protection measures must be taken by the operator. This tool features a live tool indicator (13) which illuminates as soon as the tool is connected to the supply. This warns the user that the tool is connected and will operate when the switch is pressed. To switch on the unit - use your index finger to press forward the safety lock (6) and then press the ON / OFF switch (5). To switch off the unit - just release the ON / OFF switch (5). After use, check the tool to make sure that it is in good condition. It is recommended that you take this tool to a Ryobi Authorized Service Center for a through cleaning and lubrication at least once a year. WARNING To ensure safety and reliability, all repairs should be performed by an authorized service center or other qualified service organization. [. . . ] It is recommended that you take this tool to a Ryobi Authorized Service Center for a through cleaning and lubrication at least once a year. WARNING To ensure safety and reliability, all repairs should be performed by an authorized service center or other qualified service organization. Release the wheel guard lock lever (12) then turn the tool-less wheel guard (2) to the desired position. Turning axle is 90º on either side; otherwise the guard can't be locked. [. . . ]