User manual RYOBI TR30U

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. damaged or entangled cords increase the risk of electric shock. When operating a power tool outdoors, use an extension cord suitable for outdoor use. [. . . ] Check for misalignment or bindling of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire. Under abusive conditions, liquid may be ejected from the battery; avoid contact. After normal usage, a minimum of 3 hours of charging time is required to fully recharge the screwdriver. Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature. Remove the product from the charger once it is fully charged and ready for use. wARNING Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. This screwdriver is equipped with an adjustable torque clutch for driving different types of screws into different ma te ri als. The proper setting depends on the type of ma te ri al and the size of screw you are using. WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING Always wear safety goggles or safety glasses with side shields when operating products. [. . . ] All other parts should be replaced at an Authorized Service Center. The screwdriver spindle is locked when the On/Off switch is not pressed. This enables screws to be screwed in, even when the battery is empty. This feature is convenient when working in close or tight areas where additional light is needed. [. . . ]