User manual RYOBI WS-6615X

[. . . ] Do not reach underneath the workpiece while the blade is rotating. Do not attempt to remove any offcuts while the blade is moving. The blade coasts a little while after the trigger is released. Large panels must be supported as shown in Fig. [. . . ] The riving knife should always be used except when making a plunging cut in the middle of a workpiece. Inspect for and remove any nails from the lumber before cutting. ACCESSORIES: The use of accessories or attachments other than those recommended in this manual might present a hazard. Do not stop the blade by lateral pressure on the disc. Ensure that the diameter, thickness and other characteristics of the saw blade are suitable for the tool. Do not use power tools in damp or wet locations. Do not use power tools in places where there is a risk of fire or electric shock. Avoid body contact with earthed or grounded surfaces (e. Do not let visitors touch the tool or extension cord. All visitors should be kept away from the work area. When not in use, tools should be stored in a dry, high or locked-up place, out of children's reach. It will do the job better and safer when used at the rate for which it was intended. Do not wear loose clothing or jewellery, they can get caught in moving parts. Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. If your saw comes with a dust extractor/collector, ensure it is properly connected and used. Never carry the tool by the cord or yank it to disconnect the saw from the power socket. Keep the cord away from sources of heat, oil and sharp edges. It is safer than using your hand and it frees both hands to operate the tool. Get into the habit of checking to see that all keys and adjusting spanners have been removed from the tool before turning it on. Do not carry a cordless tool with a finger on the trigger switch. Ensure the switch is off when plugging in your saw. [. . . ] The cutting angle may be set to any position between 0° and 45°. Loosen the bevel adjustment knob (16) at the front of the tool and move the base plate to the desired angle using the bevel scale (17). Once the angle has been set, be sure to retighten the bevel adjustment knob firmly. All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months from the date stated on the original invoice drawn up by the retailer and given to the end user. [. . . ]