User manual SAECO GRANAROMA SM6480

[. . . ] Removing and inserting the brew group ____________________________________________________________ A1 Control panel A2 Lid of pre-ground coffee compartment A3 Lid of bean hopper A4 Socket for cord A5 Drip tray A6 Drip tray release grip A7 Adjustable coffee and milk dispensing spout A8 HygieSteam container A9 HygieSteam cover with milk tube holder A10 Internal cappuccinatore A11 Mains cord with plug A12 Grind setting knob A13 Bean hopper A14 Brew group A15 Service door A16 Water tank A17 Coffee grounds container A18 Front panel of coffee grounds container A19 Drip tray cover A20 'Drip tray full' indicator There are two versions of this espresso machine. Their control panels look different, but all buttons and icons work in the same way. Refer to figure B for an overview of all buttons and icons. Use the up and down arrows to scroll through the display and tap the OK icon to select or confirm your choices. [. . . ] 2 Tap the OK icon to confirm and then follow the instructions on the screen. Lubricating the brew group To improve your machine's performance, we suggest that you lubricate the brew group every 2 months, to ensure that the moving parts continue to move smoothly. 1 Apply a thin layer of grease on the piston (grey part) of the brew group (Fig. 2 Apply a thin layer of grease around the shaft (grey part) in the bottom of the brew group (Fig. 3 Apply a thin layer of grease to the rails on both sides (Fig. The machines has three programs to clean the internal cappuccinatore: - 'HygieSteam Shot': the machine shoots steam through the internal cappuccinatore to rinse it quickly. - 'HygieSteam': the machine thoroughly cleans the internal milk system with steam. Make sure that Place the milk tube in the milk tube holder (Fig. 46) and follow the instructions on the screen. - 'Deep Milk Clean': Perform the 'Deep Milk Clean' procedure with the Philips milk circuit cleaner for a thorough cleaning of the internal milk system. Cleaning the internal cappuccinatore under the tap 1 Open the door of the internal cappuccinatore (Fig. 2 Remove the internal cappuccinatore by pulling it down (Fig. 3 Disassemble the internal cappuccinatore by pulling the bottom part off the top part (Fig. 5 Reassemble the internal cappuccinatore. 6 To place back the internal cappuccinatore, put it in upright position and make sure the holes are Aligned with the two tubes on the machine. Then move the internal cappuccinatore upwards until it locks into place (Fig. Under no circumstances should you use a descaler based on sulfuric acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in your machine and will not dissolve the limescale properly. Not using the Philips descaler will void your Failure to descale the appliance will also void your warranty. You can buy Philips descaler from your local or online retailer or authorized service centers. 1 When the machine asks you to descale it, tap the OK icon to start. to start descaling without being Prompted by the machine, tap the Clean icon and select 'Descale'. 2 Remove the drip tray, the coffee grounds container and the HygieSteam container (Fig. [. . . ] Make sure the water tank is in the correct position: remove it and reinsert it by pushing it into the machine as far as possible. The manufacturer reserves the right to improve the technical specifications of the product. 3) for "Flere drikke", og rul ned for at vælge "Varmt vand". Din maskine giver dig mulighed for at vælge smagsprofiler i stedet for at justere alle indstillingerne enkeltvis med CoffeeEqualizer-funktionen. [. . . ]