User manual SAECO XSMALL PLUS

[. . . ] Thank you for purchasing this highest quality espresso coffee machine and for your confidence in our company. Before operating the machine, we recommend carefully reading the operating instructions that explain how to use, clean and maintain it in perfect working order. Please refer to an authorized dealer, or to Saeco, if you have any questions. We will be happy to provide any clarifications. [. . . ] This cycle rinses the coffee circuits with fresh water. the rinse/self-cleaning cycle is carried out: · When the machine is turned on (with cold boiler) · After priming the water circuit (with cold boiler) · During the warm-up phase (if a coffee product has been brewed) · When the machine is turned off (if a coffee product has been brewed) Note: Place a container beneath the dispensing spout (5) before the dispensing starts (Fig. A small amount of water will be dispensed which will rinse and heat all the machine components; in this phase the lights will flash counter-clockwise. Wait for the cycle to finish automatically. You can stop dispensing as well, by pressing either coffee button. When water regularly comes out and the warning light (18) will blink slowly, indicating that you can turn off the control dial, rotate the control dial counter-clockwise to set it back to the " " position. At this point the temperature light (19) begins to blink slowly, indicating that the machine is in warm-up mode. Note: Before starting the machine after long periods of inactivity or if the water tank has been completely emptied, it is recommended that the circuit be primed. When warm-up is complete, the machine performs a rinse cycle of the internal circuits (see section 4. When the above steps are complete, the machine is ready for use. To brew coffee, dispense hot water or steam, and for a proper use of the machine, carefully follow the The machine that you have bought allows for certain adjustments that will permit you to use it to its full potential. Coffee is a natural product and its characteristics may change according to its origin, blend and roast. The Saeco coffee machine is equipped with a self-adjusting system that allows the use of all types of coffee beans available on the market (not including flavored or carmelized). The machine automatically adjusts itself in order to optimize the extraction of the coffee, ensuring perfect compression of the beans to obtain a creamy espresso coffee that will release all the aromas, regardless of the type of coffee used. The optimization process is a learning process that requires the brewing of a certain number of coffees to allow the machine to adjust the compactness of the ground coffee. Each time you press and release a coffee button, the machine brews a pre-programmed amount of coffee. This amount may be reprogrammed to your taste. Each button may be individually programmed for a specific brew setting. As an example, the following procedure describes the programming of the small coffee button (14), which is normally associated with espresso coffee. 12) - Press and hold down the small coffee button; the large coffee button blinks during this phase. Note: Should the machine not brew coffee, make sure that the water tank (9) contains Before brewing coffee, make sure that the green temperature light (19) is steady on and that the water tank and the coffee hopper are full. Keep the control dial (17) in the " " position, during the coffee brewing cycle. [. . . ] A fault has occurred in the brew Try again to brew another coffee. Clean the hole of the hot water/steam using a pin. Make sure that the machine is turned off and has cooled before performing this operation. T h e c o ff e e i s n o t c r e a m y The coffee blend is unsuitable, the Change coffee blend or adjust the grind enough. [. . . ]