User manual SAGEM AXIUM HTD 501

[. . . ] Dear Sagem customers, You have just bought a Flat Screen DLP™ SAGEM AXIUM™. This product was manufactured with the greatest care and we hope that it will provide you joy and spectacular sensations for many years. This product is extremely complete and we recommend that you first refer to Chapter 2 " SET UP" and Chapter 3 "First Rapid Installation" before reading the whole user manual. We recommend you to keep this document in a safe place in order to be able to refer to it afterwards. [. . . ] (Entries in DVI D mode do not need this adjustment). Horizontal position: press C to move the picture to the left and B to move it to the right. Vertical position: Press B or C to move the picture to the top or bottom. Frequency: modifies the data display frequency so that it corresponds to the frequency of your computer's graphics card. When a flashing vertical bar appears, use this function to adjust the frequency. Phase: this enables finer synchronisation with your computer's graphics card. When an unstable or flashing page occurs, use this tuning. automatic mode: yes/no carries out automatic tuning. Resolutions accepted (DVI-D and VGA entries) To ensure that the projection display is operating correctly with your computer make sure that you configure the display mode of your graphics card to a resolution lower than 1024 x 768. YES RECHERCHE Horizontal 640 640 640 640 640 800 800 800 800 1024 1024 1024 1152 1152 1280 1280 x x x x x x x x x x x x x x x x Vertical 480 480 480 480 480 600 600 600 600 768 768 768 864 864 720 1024 Hz 60 66 72 75 85 60 72 75 85 60 70 75 60 70 60 60 NB: Optimum stability is achieved with a frequency of 60 Hz (consult the documentation for your PC to configure it). SPORT You can set and save your own parameters using the "USER" mode. CONTRAST, BRIGHTNESS, COLOUR, SHARPNESS, TINT can be adjusted according to your preferences using the C and B buttons. The tone adjustment only applies to an NTSC video source. SPORT The colour balance adjustment allows you to set the main picture colour. SPORT You can choose your picture preference from the settings offered using the C and B buttons STANDARD CINEMA STUDIO SPORT Select the most suitable one for the programme you are viewing and validate using the OK button. Press the MENU button to exit and the BACK button to return to the previous screen. Sound adjustment You can adjust and save your own parameters using: AUDIO OPTIONS 55 45 +10 35 STEREO FIXED 55 INSTAL. BASS, TREBLE, BALANCE Bass allows you to accentuate the lowest frequencies. Treble allows you to accentuate the highest frequencies. BALANCE Adjusting the balance affects the levels of sound between the right and left speakers. This allows you to obtain a sound level that is suited to your listening position. WOOFER VOLUME This affects the sound volume in your woofer to allow you to balance the right and left channels. [. . . ] The ON/STANDBY indicator light flashes orange for 20s then turns to red or still flashes orange, switch off the appliance using the switch to the left of your Flat Screen DLP™. Wait 30s and restart is using the normal procedure. Check that you have selected sources that is active in PIP mode (Chapter 8. Black and white picture or picture interference. [. . . ]