User manual SAGEM D20V

[. . . ] LU 252117222C_D20V_EN. book Page 1 Mercredi, 24. août 2005 11:46 11 User guide LU 252117222C_D20V_EN. book Page 2 Mercredi, 24. août 2005 11:46 11 INTRODUCTION Dear customer: Thank you for purchasing a Sagem Commnication DECT telephone; we appreciate your trust in us. This product was manufactured with the upmost care, should you encounter any difficulties during its use, we recommend that you refer to this user guide. [. . . ] To exit the menu, press the red key . On the navigator key , press or until the BASE SET screen is displayed, press OK to confirm. 23 LU 252117222C_D20V_EN. book Page 24 Mercredi, 24. août 2005 11:46 11 BASE SETTINGS Select CHANGE CODE using OK. Press Enter the old base code using the keypad (default is 0000). Enter the new base code using the keypad. It must be composed of 4 digits miminum up to 8 digits maximum. Confirm by entering the new base code again. To exit the menu, press the red key . Note carefully the new base code on the back cover, you will need it to modify some parameters. Re-initialise the base When you re-initialise your base, all the base parameters are reset to their initial values (factory settings). On the navigator key , press or until the BASE SET screen is displayed, press OK to confirm. To exit the menu, press the red key . When you re-initialise the base, the base code becomes 0000 again and the voice box number must be reprogrammed. "Modifying the voice box number", page 21. 24 LU 252117222C_D20V_EN. book Page 25 Mercredi, 24. août 2005 11:46 11 REGISTRATION REGISTRATION Five SAGEM D20 handsets can be logged on to one base station. A handset can be logged on to up to four different base stations. On the base: Put the base to which you want to link the telephone set in registration mode and press the base button for several seconds. The green light blinks rapidly, the base is in link mode during 3 minutes maximum. The new handset and the base are mutually searching for each other. The link may take from several seconds up to three minutes. Once the handset is registered, you will hear an acoustic signal and the number assigned to the handset is displayed at the left of the screen. The handset and the base then automatically quit the pairing mode. If the handset put out an irregular acoustic signal, pairing has aborted. Disconnect and re-connect the power supply cord of the base and repeat the procedure. To exit the menu, press the red key Select REGISTER HS using OK. Press . Registering an additional handset to a base To register an additional handset to a base you must: · put the handset in registration mode, · put the base in registration mode. Once this is done, the registration (mutual recognition of the base and the new handset) will be done automatically (registration can take a few seconds). [. . . ] Your handset is not registered on a base, (refer to paragraph Registering an additional handset to a base, page 25). Note: When the handset is not registered on a base, you can only access to the REGISTRATION menu. Inopportune ringing When the messages in the voice box have been consulted, the message presence indicators are turned off by the service provider. You may hear a short beep indicating this function. D20T cannot make call Registration fail The handset displays "NOT REGIST" 38 LU 252117222C_D20V_EN. book Page 39 Mercredi, 24. [. . . ]