User manual SAGEM HL10

[. . . ] Do not place anything on your radio (this may hinder correct ventilation): the air vents on the casing protect your device from overheating. If you place your radio in a compartment, leave at least 10 cm on either side and 20 cm at the front and rear. Only alkaline batteries are recommanded to be used for this product. Only use the power supplied unit, and connect it to the mains according to the installation instructions in this manual and the indications on the identification label located next to the battery compartment and the power supply unit supplied (voltage, current, mains network frequency). [. . . ] 1 2 3 4 5 6 7 8 9 10 11 12 13 Keys Loud speaker Screen Menu key Stations key Volume key Knob Lock button FM/PM/PO/GO Modes key FM / AM PO / GO Used to. . . Note: 150 mV maximum output To switch the radio On/Off. To connect the power transformer. See. . . Aerial On/Off switch Preselection keys 1 - 5 Power outlet 4 THE SCREEN During operation or on standby, your radio screen will inform you by means of icons of the status of your radio. Depending on the radio status, the following icons may be displayed: 1 FM AM SW LW 4 12:03 5 6 7 8 9 2 3 107. 7 --------- No. Message display zone. USING THE KNOB The radio is equipped with a multifunction knob. 1 2 Listening In the menus Scroll through the menus. Define a value (for example to set the time). Confirm a setting. Turn the knob to Look for a station. - 5 EN SWITCHING THE RADIO ON / OFF Press the key on the top of the radio. Only the time remains displayed on the Standby: press briefly on the screen. BROWSING THE MENUS 1. Scroll through the menus by turning the knob. When the required menu is displayed: press the knob to enter this menu, or press the key to return to the previous screen. To exit the main menu, press the You will automatically exit the main menu after a few seconds of inactivity. MENU OVERVIEW The following menus depend on the radio model you have. Alarm Alarm1 Alarm2 Alarm3 Standby Off 10 mins | 90 mins Configuration Initial configuration Language Time Station search Audio FM Automatic Manual Stereo Mono 6 SWITCHING ON Only use approved chargers and accessories for use with this model. Connecting other accessories may be dangerous and void your warranty rights. CHOOSING THE ADAPTER Choose the adapter according to your country. Align the adapter with its housing and slide it in the power transformer as illustrated here, until it clips into place. If you cannot align the adapter in its housing, do not force it. You must be handling it in a wrong way. SWITCHING ON YOUR RADIO 1. Take the power jack ang plug it on the radio. The screen lights USING THE RADIO DAILY LOCKING / UNLOCKING THE RADIO To carry your radio while it is on, place the button on the right side of your radio in the raised position. The control buttons are inactive. POSITIONING THE AERIAL For optimal reception, unfold the aerial. If necessary, move it to adjust the position. [. . . ] To remove the automatic sleep function, select the Off option and confirm. RESETTING THE RADIO If necessary, you can reset the radio to its initial settings. If you reset the radio, you will lose your personal settings. In the Configuration > Initial configuration menu, select Yes and confirm. Now the radio is on factory settings. CHANGING THE DISPLAY LANGUAGE In the Configuration > Language menu, select the desired language and confirm. The messages are displayed in the chosen language. CHANGING THE TIME DISPLAY The time is displayed in the format HH:MM 1. [. . . ]