User manual SAGEM MDP 1600

[. . . ] English FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Position the lid over the compartment and snap it back into place. Keep the battery out of the reach of children. There is a danger of death by accidentally swallowing the battery. Do not recharge the used battery or expose the battery to fire or water. Do not dispose of the used battery along with household waste. Dispose of used batteries according to local regulations. Danger of explosion may happen if a battery is incorrectly replaced. Replace only with the same type recommended by the manufacturer. EN-22 English Remote Control Operation Point the remote control at the infrared remote sensor and press a button. 3m 20 20 3m 20 20 Distance: within about 3 meters from the front of the remote control. Angle: within about 20 degrees of the remote sensor in every direction. The remote control may not operate when there is sunlight or other strong light such as a fluorescent lamp shining on the remote sensor. Operate the remote control from a position where the remote sensor is visible. Do not drop the remote control or jolt it. Keep the remote control out of locations with excessively high temperature or humidity. Do not get water on the remote control or place wet objects on it. Under unusual circumstances the remote control may not operate well due to the location being used or the surroundings. At such times, change the direction of the remote control to the projector and retry the operation. EN-23 Menu Options The projector has multi-language OSD (On-Screen Display) menus that can only be displayed when an input source is present. The menus can be accessed using either the Projector Control Panel or the Remote Control. The OSD (On-Screen Display) menus allow you to make image adjustments and change a variety of settings. If source is a computer, the OSD (On-Screen Display) allows changes to the Display tab. When using a video source, the OSD (On-Screen Display) allows changes to the Video tab. The projector automatically detects the source. 1. Press the MENU\ENTER button on the Projector Control Panel or the Menu button on the Remote Control. Select the menu tab with the / buttons either on the Projector Control Panel or the Remote Control. Select the desired menu option item with the / buttons either on the Projector Control Panel or the Remote Control. [. . . ] Otherwise it could be harmful to user's health. EN-34 English 1. Turn off the projector and unplug the AC power cord. Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can access the lamp cover. [. . . ]