User manual SAITEK IFREEDOM A-250 WIRELESS SPEAKER

[. . . ] Open the music player on your PC (Windows Media Player, iTunes etc). Select the album or playlist you want to hear and press "play". The computer should automatically play the music through the USB transmitter rather than its speakers or headphone socket. Please see the Troubleshooting section at the end of this guide if the Wireless Speaker system does not start to play the music from your computer. [. . . ] To save battery life or when the batteries have expired, if you are near a mains power source you can power the wireless speaker system using the AC Adapter supplied. Simply plug it into a mains socket and then plug the cable into the power socket on the rear right-hand side of the wireless speaker system. Note that the speaker system will only function at its highest volume when the connected to the AC Adapter. Check that your PC system volume is not at 0. if it is , increase the volume control to the desired level. 5mm jackplug input, check that your music player's volume setting is not at 0. Check that the speaker system is within 30m range of your computer and that there are no solid metal barriers blocking the wireless signal. If necessary, move the speaker system nearer the computer and remove any large obstructions. Music is playing through my speaker system but the pause, previous track/next track buttons do not work. Ensure the music player window on PC is not minimised. When I stop or play tracks directly on my computer's music player, the speaker system will no longer control the computer. When you first turn your speaker system on it will automatically tell your computer's music player to stop playing. The Saitek speaker system will then be able to directly control the stop and play functions on your music player. To avoid "confusing" the computer, always control tracks using your speaker system's controls and not your computer. If your music player does not respond to your speaker system's controls, quit and then restart the music player application. The Saitek A-250 Wireless speaker system is equipped with a backlit LCD display which indicates battery life, volume, play status, and wireless or wired connection. The screen backlighting illuminates when you press " "and after any key press. After 10 seconds, the backlighting switches off to save power. When you switch the wireless speaker system on the unit will automatically "look" for the wireless transmitter to connect. While the speaker system is looking for the transmitter, the LCD screen will show "-----" and the wireless indicator will flash to show that the wireless link is not established. When the transmitter has been discovered and both units are ready, the wireless indicator stops flashing and will show "OK". If the connection to the transmitter is lost or not established (perhaps because it is out of range), the LCD will show "-----" and the wireless indicator will flash again. [. . . ] If LINE is the source, Volume UP "+" and Volume Down "-" operate as normal but you will be unable to control track selection. to switch back to the wireless audio source , press and hold " " button for 3 seconds. The unit switches back to the wireless mode, and after the signal is found, the LCD shows OK. When the battery level is down to the last bar, the battery icon starts to flash and BATT is displayed on screen. [. . . ]