User manual SAITEK KASPAROV

[. . . ] We design and manufacture professional light equipment for the entertainment industry. New products are being launched regularly. We work hard to keep you, our customer, satisfied. For information, please visit our web site at http://www. highlite. nl. [. . . ] after transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the device switched off until it has reached room temperature. If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely (preferably in the original packing material), and return it to your Showtec dealer for service. For replacement use fuses of same type and rating only. This device falls under protection class I. Therefore it is essential to connect the yellow/green conductor to earth. Repairs, servicing and electric connection must be carried out by a qualified technician. WARRANTY: Till one year after date of purchase. OPERATING DETERMINATIONS If this device is operated in any other way, than the one described in this manual, the product may suffer damages and the warranty becomes void. Any other operation may lead to dangers like short-circuit, burns, electric shock, explosion, crash etc. 2) Audio Input ; Line in 100mV-1Vpp 3) Channel Fuse ; F6. 3A 250V 5x20mm 4) Channel Output ; 2A /CH. , 8A /Total (CE) 5) Channel Output ( 6 PIN Socket x 2 ; Use to connect to output fixtures, pin arrangement is referred to the drawing printed in the rear panel. 5 50307 Lite-Power 4B (with Bulgin connectors) 1) AC Input ; Plug in appropriate power supply. 2) Audio Input ; Line in 100mV-1Vpp 3) Channel Fuse ; F6. 3A 250V 5x20mm 4) Channel Output ; 2A /CH. , 8A /Total (CE) 6 Installation Remove all packing materials from the Lite-Power 4. Check that all foam and plastic padding is removed. Screw the equipment into a 19" rack. Always disconnect from electric mains power supply before cleaning or servicing. Damages caused by non-observance are not subject to warranty. Set Up and Operation Before plugging the unit in, always make sure that the power supply matches the product specification voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa. Operating mode is controlled by MODE SELECT. You can select operating mode from Hold Dimmer / Hold Sound / Prog Sound / Prog Speed / Auto Speed /Auto Sound / Memory. Hold Dimmer Hold Sound Prog Sound Corresponding indicator lights. Channel output is controlled by Channel Dimmer control or Master Dimmer control. [. . . ] If you fail lin certain step, you should restart programing, otherwise not effective. Press Prog Select once, program will be executed one step, and PROGRAM DISPLAY will show the information. You can refer to the way mentioned in Prog Sound to select desired step. Prog Speed Auto Speed Auto Sound Memory PR mode ST mode 7 AS mode AP mode Program is executed according to the music rhythms and PROGRAM DISPLAY shows the step. Program is executed automatically and PROGRAM DISPLAY shows the step. [. . . ]