User manual SAMMY PRIZE PARTY

[. . . ] IF THE GAME IS NOT ON A LEVEL SURFACE, THE TILT SYSTEM WILL MALFUNCTION. USE A LEVEL TO AVOID NEEDLESS ADJUSTMENTS. SAFETY PRECAUTIONS Be sure to turn the power off or unplug the game before working on the unit. Do not unplug game by pulling on the line cord. Replace line cord if the insulation is damaged in any way with one of equal quality. [. . . ] Control the Car using steering wheel to hit the FLAGS. More FLAGS, more tickets. GAME SETTING MODE HOW TO ENTER THE GAME SETTING MODE Re-power on while pressing and holding the RESET Switch which is located inside of front door. Then release the RESET switch OFF to show the ­1 on 2 digits LED display on Marquee box. HOW TO SELECT AND DECIDE EACH CONTENTS After entering GAME SETTING mode, press SERVICE switch to move the number of FUNCTIONS. (2 digits will be changed by pressing the SERVICE switch. ) Press RESET switch to select it. After selecting, display shows each setting numbers. Press SERVICE switch to move the number of SETTINGS. (2 digits will be changed by pressing the SERVICE switch) Press RESET switch to select it. RETURN TO PREVIOUS MENU Change FUNCTIONS and SETTINGS to selection "oo". Select these Digits then press RESET switch to return to previous menu. RETURN TO GAME MODE After selecting any SETTINGS, re-power on the game. For the FUNCTIONS and SETTINGS, please refer to the setting table on next page. DIP SW SETTING Payout setting is set by DIPSW on Main PCB. Please refer below table. DIP SWITCH 1 FUNCTIONS PAYOUT SETTING SETTING REDEMPTION GAME CARD PAYOUT EXTEND GAME OFF NOTE Ticket payout. SWITCH POSITION 1 OFF ON ON OFF 2 OFF OFF ON OFF 3 OFF OFF OFF ON ATTEMTION!!!(Receiver and Sender. ) Count the hole on left side of Belt. Lamp #3: Adjusting sensor Located Left bottom of BELT from back side view. Reflector Located Left top of BELT from back side view. Reading the Black and White marks on Right side of Belt. Photo Reflector KR291-AA Part #: 41-60-559 Adjusting Sensor Photo Sensor, KB1240-AA Part #: 41-60-558 BACK VIEW OF CABINET Positioning Sensor Photo Sensor, KB1240-AA Part #: 41-60-558 VENDING DEVICE TEST (Press SERVICE switch to select 23, then press RESET switch. ) Press SERVICE switch to payout Ticket or Card when the setting is Ticket or Card Payout. SOUND TEST Display shows 3­ then press SERVICE switch to go to SOUND TEST. Press RESET switch to count up the number on Display and output the sound. Press & hold to skip thru the numbers faster. Press SERVICE Switch and Display shows oo, then press SERVICE Switch again to return to previous menu. RETURN TO GAME MODE After TESTING, re-power on the game. 9 ERRORS Display Shows Contents of ERROR Card or Ticket Empty Cause of problem and Solution. Check the Card or Ticket Dispenser. If empty, re-fill the Cards or Tickets and press RESET switch to payout remaining number of Cards or Tickets. Do not power off because remaining number will be cleared. Check the Card or Ticket Dispenser, clear the jam of Cards or Tickets and re-power on the game. Any jamming in the coin or token in there or not? [. . . ] Open Playfield dome and check the Car Assy mounting. If error is not cleared, need to exchange the Main PCB. Check wiring and pin connection of XMech. Check the Card or Ticket Dispenser harness, connection. . . etc. [. . . ]