User manual SAMSUNG 153S

[. . . ] SyncMaster 153V/173V/152V/172V/193V/192V/153S/173S/153B/173B Main Page Safety Instructions Notational Power Installation Cleaning Other Introduction Unpacking Front Rear Setup Connecting Your Monitor Installing the Monitor Driver Automatic Manual Installing VESA compliant mounting On-Screen Display Troubleshooting Check List Q&A Self-Test Feature Check Specifications General Specifications PowerSaver Preset Display Modes Information Service Terms Regulatory Natural Color For Better Display Authority Notational Power Installation Clean Other Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. Notational Power Installation Clean Other Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and reoeptacle. [. . . ] Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. General Model Name General PowerSaver Preset Timing Modes SyncMaster 153S LCD Panel Size Display area Pixel Pitch Type Viewing Angle Synchronization Horizontal Vertical Display Color 16, 194, 277 Colors Resolution Optimum resolution Maximum resolution Input Signal, Terminated RGB Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, Composite, Sync-on-Green TTL level positive or negative Maximum Pixel Clock 80 MHz Power Supply AC 90 ~ 264 VAC, 60/50 Hz ± 3Hz Signal Cable 15pin to 15pin D-sub cable, Detachable Power Consumption 32W (Maximum) Dimensions (WxDxH) / Weight 353. 0 x 152 x 350. 0 mm / 3. 8kg VESA Mounting Interface 75mm x 75mm (for use with Specialty(Arm) Mounting hardware. ) Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Dot Acceptable Temperature: 50°F ~ 104°F(10°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing 1024 x 768@60Hz 1024 x 768@75Hz 31 ~ 61 kHz 56 ~ 75 Hz 15. 0 inch diagonal 304. 1 (H) x 228. 1 (V) 0. 297 (H) x 0. 297 (V) a-si TFT active matrix 140/115(H/V) TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99. 999% above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness. For example, the number of TFT LCD pixels that is contained in this product are 2, 359, 296. Note: Design and specifications are subject to change without prior notice. General Model Name General PowerSaver Preset Timing Modes SyncMaster 173S LCD Panel Size Display area Pixel Pitch Type Viewing Angle Synchronization Horizontal Vertical Display Color 16, 194, 277 Resolution Optimum resolution Maximum resolution Input Signal, Terminated RGB Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, Composite, SOG TTL level positive or negative Maximum Pixel Clock 135 MHz Power Supply AC 90 ~ 264 VAC rms, 60/50 Hz ± 3Hz Signal Cable 15pin-to-15pin D-sub cable, detachable Power Consumption 40W (Maximum) Dimensions (WxDxH) / Weight 382. 0 x 177. 0 x 392. 5 mm / 5. 1kg VESA Mounting Interface 75mm x 75mm (for use with Specialty(Arm) Mounting hardware. ) Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Dot Acceptable Temperature: 50°F ~ 104°F(10°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing 1280 x 1024@60Hz 1280 x 1024@75Hz 31 ~ 81 kHz 56 ~ 75 Hz 17. 0 inch diagonal 337. 92 (H) x 270. 336 (V) 0. 264 (H) x 0. 264 (V) a-si TFT active matrix 140/120(H/V) TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99. 999% above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness. of TFT LCD pixels that is contained in this product are 3, 932, 160. Note: Design and specifications are subject to change without prior notice. General Model Name General PowerSaver Preset Timing Modes SyncMaster 153B LCD Panel Size Display area Pixel Pitch Type Viewing Angle Synchronization Horizontal Vertical Display Color 16, 194, 277 Colors Resolution Optimum resolution Maximum resolution Input Signal, Terminated RGB Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, Composite, Sync-on-Green TTL level positive or negative Maximum Pixel Clock 80 MHz Power Supply AC 90 ~ 264 VAC, 60/50 Hz ± 3Hz Signal Cable 15pin-to-15pin D-sub cable, detachable Power Consumption 36W (Maximum) Dimensions (WxDxH) / Weight 353. 9 x 152 x 360. 0 mm / 3. 8kg VESA Mounting Interface 75mm x 75mm (for use with Specialty(Arm) Mounting hardware. ) Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Dot Acceptable Temperature: 50°F ~ 104°F(10°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing 1024 x 768@60Hz 1024 x 768@75Hz 31 ~ 61 kHz 56 ~ 75 Hz 15. 0 inch diagonal 304. 1 (H) x 228. 1 (V) 0. 297 (H) x 0. 297 (V) a-si TFT active matrix 140/115(H/V) TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99. 999% above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness. For example, the number of TFT LCD pixels that is contained in this product are 2, 359, 296. [. . . ] Enter D:\color\eng\setup. exe and then press the <Entrer> key. (If the drive where the CD is inserted is not D:\, enter the applicable drive. ) How to delete the Natural Color software program Select [Setting]/[Control Panel] on the [Start] menu and then double-click [Add/Delete a program]. Select Natural Color from the list and then click the [Add/Delete] button. For Better Display 1. Adjust computer resolution and screen injection rate (refresh rate) in control panel of computer as described below to enjoy the best quality of picture. [. . . ]