User manual SAMSUNG SYNCMASTER 210P PLUS EN

[. . . ] SAMTRON 210P plus Main > Index Main Page Safety Instructions Notational Power Installation Cleaning Other Introduction Unpacking Front Rear Bottom Setup Connecting Your Monitor Installing the Monitor Driver Automatic Manual Base Installation On-Screen Display Troubleshooting Check List Q&A Self-Test Feature Check Specifications General Specifications Preset Timing Modes PowerSaver Information Service Terms Regulatory Authority Main > Safety Instructions > Notational Notational Power Installation Clean Other Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Main > Safety Instructions > Power When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. Notational Power Installation Clean Other If the size of your monitor is small, or if the same image is present for long periods of time, you may see afterimages due to damage to the fluorescent substance on the inside of the CRT. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and recepticle. [. . . ] Note: When you are finished, wait for a few seconds and the screen will blank then display the image from the new signal source(other computer). A cable must be connected to both inputs to use this function. Push the button or button until the Advanced screen is displayed. Push the button or button to select D-SUB/BNC. Push the Menu ( ) button to open the D-SUB/BNC selection screen. Use the button or button to select D-SUB or BNC. On-Screen Display Menu How to adjust Display timing You can see the frequency (user control mode) used by the user, the polarity of the operational signals, the default frequency (default mode) set when you buy the monitor and the resolution level. Note: These screens do not allow any changes to the settings, they are for information only. Push the button or button until the Menu screen is displayed. Push the Menu ( ) button to open the Display Timing adjustment screen. Use the button to see the user control mode and the default mode. Menu Position You can change the position where the OSD menu appears on your monitor. Push the button or button until the Menu screen is displayed. Push the button or button to select Menu Position. Push the Menu( ) button to open the Menu Position adjustment screen. Use the button or button to place the menu in the position you prefer. On-Screen Display Menu How to adjust Menu Duration The menu will automatically turn off if no adjustments are made for a certain time period. You can set the amount of time the menu will wait before it turns off. Push the button or button until the Menu screen is displayed. Push the button or button to select Menu Duration. Push the Menu ( ) button to open the Menu Duration selection screen. Use the or buttons to select 3, 7, 10, 20 or 50 seconds. 10 seconds is the default value. Languages Follow these steps to change the language used in the menu. English, German, French, Italian, Portuguese, Spanish, Swedish, Russian, Polish , or Magyar. (Some OSD languages may not appear in some areas. ) The language chosen affects only the language of the OSD. [. . . ] Cadmium damages the nervous system and is toxic in high doses. The relevant TCO'99 requirement states that batteries, the colour-generating layers of display screens and the electrical or electronics components must not contain any cadmium. Mercury** Mercury is sometimes found in batteries, relays and switches. It damages the nervous system and is toxic in high doses. [. . . ]