User manual SAMSUNG SYNCMASTER 245BPLUS

[. . . ] LCD MONITOR quick start guide 245BPLUS Package Contents Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Contact a local dealer to buy optional items. Unpacking Without Stand Monitor With Stand Monitor & Sliding Stand Manual Quick Setup Guide Warranty Card (Not available in all locations) User's Guide, Monitor Driver, Natural Color, MagicTuneTM Cable Power Cord D-sub Cable Sold separately DVI Cable Others Cleaning Cloth This is only provided for highly polished black products as a product feature. Speaker package(option) Speaker Your Monitor Front MENU button [ ] Opens the on-screen menu and exits from the menu. [. . . ] Do not fasten the screws too tightly, as this may damage the product or cause the product to fall, leading to personal injury. Samsung is not liable for these kinds of accidents. Samsung is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used or the consumer fails to follow the product installation instructions. To mount the monitor on a wall, you should purchase the wall mounting kit that allows you to mount the monitor at least 10cm away from the wall surface. Contact the nearest Samsung Service Center for more information. Samsung Electronics will not be responsible for damages caused by using a base other than those specified. Please use Wall Mount according to the International standards. Check List Before calling for service, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call the phone number on the Information section or contact your dealer. Symptom No images on the screen. I cannot turn on the monitor. Check List Is the power cord connected properly?Can you see "Check signal cable" on the screen? Solutions Check the power cord connection and supply. (Connected using the D-sub cable) Check the signal cable connection. (Connected using the DVI cable) If you still see an error message on the screen when the monitor is connected properly, check to see if the monitor status is set to analog. Press ' ' button to have the monitor double-check the input signal source. If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card. (Refer to the Preset Timing Modes) If the initial screen (the login screen) does not appear, contact the Service Center or your dealer. If the power is on, reboot the computer to see the initial screen(the login screen), which can be seen. Can you see "Not Optimum Mode", "Recommended Mode 1920 x 1200 60 Hz" on the screen? You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can handle properly. Adjust the maximum resolution and frequency that the monitor can handle properly. If the display exceeds SXGA or 75 Hz, a "Not Optimum Mode", "Recommended Mode 1920 x 1200 60 Hz" message is displayed. If the display exceeds 85 Hz, the display will work properly but the "Not Optimum Mode", "Recommended Mode 1920 x 1200 60 Hz" message appears for one minute and then disappears. Please change to the recommended mode during this one-minute period. (The message is displayed again if the system is rebooted. ) There is no image on the screen. Is the power The monitor is in PowerSaver mode. Press a key on the keyboard to activate the monitor and indicator on the monitor blinking at 1 second intervals? restore the image on the screen. If there is still no image, press the ' ' button. [. . . ] Contact the video card manufacturer for details. How can I set the Power Saving function?Windows XP : Set the resolution at the Control Panel Appearance and Themes Display Screen Saver. Set the function at BIOS-SETUP of the computer. [. . . ]