User manual SAMSUNG SYNCMASTER 400DX-3

[. . . ] SyncMaster 400DX-3/460DX-3 LCD Display User Manual The color and the appearance may differ depending on the product, and the specifications are subject to change without prior notice to improve the performance. Safety Instructions Notational Note These safety instructions must be followed to ensure your safety and prevent property damage. Make sure to read the instructions carefully and use the product in the correct manner. Warning / Caution Failure to follow directions noted by this symbol could result in bodily harm or damage to the equipment. Note Important to read and understand at all times Disconnect the plug from the outlet Ground to prevent an electric shock Prohibited Do not disassemble Do not touch Power When not used for extended period of time, set your computer to DPM. If using a screen saver, set it to active screen mode. [. . . ] Selected one display: Fetches and displays the settings value for the selected display. Selected one display (ID1) and add another display (ID3): The program, which was displaying the settings value of ID 1, fetches and displays the value of ID3. If all sets are selected at the same time by clicking All and Select, the default value will be restored. Ehternet MDC Introduction Unlike the previous method which used the serial data communication specifications RS-232C, an Ethernet function has been added. Connect the first display device and the PC by entering the IP address. To connect to another display device, use an RS-232C serial cable. Refer to the figure above. Main Screen Click Start > Program > Samsung > MDC System to start the program. Select a set to see the volume of the selected set within the slider. Main Icons Add a Device Remote Control Safety Lock Fault Device Alert 1. Use the main icons to switch into each screen. Lamp Control Display Selection All Control Tools OSD Display You can add a device by entering the IP address configured on the monitor. Allows you to enable or disable the remote control signal receiving function of the display unit. When setting the Lock function, you can only operate power and lock buttons on the remote control and set. When connecting to the monitor fails, it turns the function that transfers the result through an email on or off. Select a display from Display Selection. All of the monitors can be selected or deselected. Use Control Tools to control displays. 10. - May not be supported depending on the product. <Note> The remote control Enable/Disable function operates whether or not the power is On/Off, and this applies to all displays connected to the MDC. However, regardless of the status at the time the MDC is shut down, the remote control signal receiving function of all displays is initialized to Enable when the MDC is closed. Add a Device 1. Enter the IP address of the monitor to be connected and press the Add button to add the IP address. If you click the OK button, adding the monitor is completed. System 1. Click System in the main menu to open the system adjustment screen. Info Grid shows some basic information necessary to System. 1) (Power Status) 2) Input 3) Image Size 4) On Timer 5) Off Timer 2. Selects displays you want to adjust using the Select All button or checkboxes. System allows controlling some of the functions of the selected display. [. . . ] The Non-Interlace method is used for the majority of monitors to ensure a clear image. The Interlace method is the same as that used in TVs. This is a function that provides the best quality screen for the user by allowing the computer and the monitor to exchange information automatically. This monitor follows the international standard VESA DDC for the Plug & Play function. [. . . ]