User manual SAMSUNG 460UX-2 POWER CONSUMPTION GUIDE (VER.1.0)

[. . . ] Also use to exit the OSD menu or return to the previous menu. Navigate buttons (Up-Down buttons) Moves from one menu item to another vertically or adjusts selected menu values. Adjust buttons (Left-Right buttons) / Volume buttons Moves from one menu item to another horizontally or adjusts selected menu values. When OSD is not on the screen, push the button to adjust volume. [. . . ] When pressing this button, the current mode is displayed at the bottom centre of the screen. The LCD Display has a built-in high fidelity stereo amplifier. Then press the button again to circle through available preconfigured modes. ( Standard Music Movie Speech Custom ) Press the button once to freeze the screen. In PC/DVI mode, sets the SOUND to FM Radio. In general Video mode, selects FM Radio, and turns off the screen. In areas where the signal is weak, noise may occur during FM radio broadcasts. - This fuction does not work for this LCD Display. SRS DUAL/MTS Press to change the screen size. SRS DUALSTEREO/MONO, DUAL l / DUAL ll and MONO/NICAM MONO/NICAM STEREO can be operated depending on the broadcasting type by using the DUAL button on the remote control while watching TV. MTSYou can select MTS (Multichannel Television Stereo) mode. Match each of the brackets and hinge holes to the corresponding anchor holes and insert and tighten the 11 screws A. To mount the product on the wall bracket The shape of the product may vary depending on the model. (The assemblies of the plastic hanger and the screw are the same) 1. Remove the 4 screws on the back of the product. Introduction 2. Insert the screw B into the plastic hanger. Notice · · · 3. Mount the product on the wall bracket and make sure it is properly fixed to the left and right plastic hangers. Be careful when installing the product on the bracket as fingers can be caught in the holes. Make sure the wall bracket is securely fixed to the wall, or the product may not stay in place after installation. Tighten the 4 screws in step 2 (plastic hanger + screw B)to the rear holes of the product. 4. Remove safety pin (3) and insert the 4 product holders into the corresponding bracket holes (1). Then place the product(2) so that it is firmly fixed to the bracket. Make sure to re-insert and tighten the safety pin (3) to securely hold the product to the bracket. Introduction ABC- LCD Display Wall Bracket Wall Wall Bracket Angle Adjustment Adjust the bracket angle to -2° before installing it on the wall. 1. 3. Fix the product to the wall bracket. Hold the product at the top in the center and pull it forward (direction of the arrow) to adjust the angle. You can adjust the bracket angle between -2° and 15°. Make sure to use the top center, and not the leftor the right side of the product to adjust the angle. Connections Connecting a Computer Using a Power cord with Earth · In the event of failure, the earth lead may cause electric shock. [. . . ] 3) Enter the BIOS menu of your set by pressing the F2 key in the BIOS logo screen. Then, enable the USB Boot First option by selecting that option and pressing the Enter key in the Boot menu. 4) Switch your set on while your USB disk is connected and boot up in DOS mode. 5) Run C:\ghost. exe and choose Local Partition From Image from the menu. [. . . ]