User manual SAMSUNG 550DX

[. . . ] SyncMaster 550DX LCD Display User Manual The color and the appearance may differ depending on the product, and the specifications are subject to change without prior notice to improve the performance. Safety Instructions Notational Note These safety instructions must be followed to ensure your safety and prevent property damage. Make sure to read the instructions carefully and use the product in the correct manner. Warning / Caution Failure to follow directions noted by this symbol could result in bodily harm or damage to the equipment. Note Prohibited Important to read and understand at all times Disconnect the plug from the outlet Ground to prevent an electric shock Do not disassemble Do not touch Power When not used for extended period of time, set your computer to DPM. If using a screen saver, set it to active screen mode. [. . . ] 5) Color - Adjusts Color of the selected display. 6) Tint - Adjusts Tint of the selected display. 7) Color Tone - Adjusts the Color Tone for the selected display. 8) Color Temp - Adjusts the Color Temp for the selected display. 9) Brightness Sensor - Adjusts the Brightness Sensor for the selected display. 10) Dynamic Contrast - Adjusts the Dynamic Contrast for the selected display. Brightness Sensor may not be supported depending on the product. The Input source of MagicInfo works only on MagicInfo model. Color Temp is only enabled if the Color Tone is set to Off. The Input source of TV works only on TV model. This feature is available only for the displays whose power status is ON and if no selection is made, the factory default is displayed. HDMI2 may not be supported depending on the product. Setting Picture PC 1. Click Settings of the main icons and the Settings Control screen appears. Basic information required to adjust settings is displayed. Settings for the corresponding SET will be imported and displayed on the slider if a display ID is selected, and the default settings will be displayed if all display IDs are selected by clicking All and Select. If a value is changed in this screen, the current mode will automatically switch to custom mode. 1) Picture PC - Available only for PC, BNC, DVI and DP. 2) Contrast - Adjusts Contrast of the selected display. 3) Brightness - Adjusts Brightness for the selected display. 4) Red - Adjusts red Color of the selected display. 5) Green - Adjusts green Color of the selected display. 6) Blue - Adjusts blue Color of the selected display. 7) Color Tone - Adjusts the Color Tone for the selected display. [. . . ] The inverse number of the Horizontal Cycle is called Horizontal Frequency. Unit: kHz Showing the horizontal lines of the screen from the top to the bottom sequentially is called the Non-Interlace method while showing odd lines and then even lines in turn is called the Interlace method. The Non-Interlace method is used for the majority of monitors to ensure a clear image. The Interlace method is the same as that used in TVs. [. . . ]