User manual SAMSUNG SYNCMASTER 570PTFT

[. . . ] SyncMaster 570P TFT 570P TFT 580P TFT TFT-LCD Monitor Owner's Instructions Information in this document is subject to change without notice. © 1999 Samsung Electronics Co. , Ltd. Reproduction in any manner whatsoever without the written permission of Samsung Electronics Co. , Ltd. shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. [. . . ] The setting slidebar moves and the numeric value indicator changes to reflect your adjustments. 5 Push the EXIT button once or twice to return to the main menu to select another function or push the EXIT button 1 to 3 times to exit from the OSM. OSM functions and adjustments Table 2. Screen controls Icon Menus and Sub-menus Function Descriptions ­ + Brightness Contrast 13 Portuguese Italiano Español Deutsch NOTE: The numeric value indicator is provided as a point of reference only and does not reflect any measureable value. Français English Adjusting Your TFT-LCD Table 2. Screen controls (Continued ) Icon Menus and Sub-menus Function Descriptions ­ + Image Lock: Image Lock is used to fine tune and get the best image by removing noises that delivers unstable images with jitters and shimmers. The Fine and Coarse adjustments allow you to fine tune the image quality of your monitor to your preference. Use the "­" and "+" buttons to remove any noise. If satisfactory results are not obtained using the Fine adjustment, use the Coarse adjustment and then use Fine again. This function may change the width of the display image. Use the H-Position menu to center the display image on the screen. Fine Coarse Fine Coarse Position Moves the position of the image to horizontal or vertical direction. H-Position 14 Adjusting Your TFT-LCD Table 2. Screen controls (Continued ) Icon Menus and Sub-menus Function Descriptions ­ + V-Position Color Image size Recall 15 Portuguese Italiano Monitor parameters are replaced with factory default values by this function. Color : Color parameters are replaced with the factory default values. Geometry : Position and Image Lock parameters are replaced with the factory default values. Español The size of the image being displayed can be handled in several different ways. Expanded 1: Resize the image to fill the whole screen. Expanded 2: Keep the aspect ratio of the incoming image. Normal: Display the incoming image as it is. Deutsch The tone of color can be changed from bluish white to reddish white that is from Cool to Warm respectively. The individual color components are also user customizable. Mode 1 : Bluish white Mode 2 : White Mode 3 : Reddish White Français English Adjusting Your TFT-LCD Table 2. Screen controls (Continued ) Icon Menus and Sub-menus Function Descriptions ­ + Input Source Select the source of the video signal. (15-pin D-sub) Video : VCR signal is selected. (RCA connector is supposed to be connected to a VCR). S-Video : S-Video signal from VCR or DVD or other A/V devices are selected. (S-Video connector is supposed to be connected to a A/V devices) Image being displayed can be soften or sharpen. [. . . ] Consult the dealer or an experienced radio/TV technician for help. IC Compliance Notice User Information Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. If necessary, consult your dealer or an experienced radio/television technician for additional suggestions. You may find the booklet called How to Identify and Resolve Radio/TV Interference Problems helpful. This booklet was prepared by the Federal Communications Commission. [. . . ]