User manual SAMSUNG SYNCMASTER 710VT

[. . . ] SyncMaster 173VT / 710VT Main Page Safety Instructions Notational Power Installation Cleaning Other Introduction Unpacking Front Rear Setup Connecting Your Monitor Installing the Monitor Driver Automatic Manual Installing a VESA Base Adjusting Your LCD Monitor On-Screen Display Troubleshooting Check List Q&A Self-Test Feature Check Specifications General Specifications PowerSaver Preset Timing Modes Information Service Center Terms Regulatory Natural Color For Better Display Authority Notational Power Installation Cleaning Other Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock When not used for extended periods of time, set your Computer to DPMS. If using a screen saver, set it to the active screen mode. Notational Power Installation Cleaning Other Do not use a damaged or loose plug. ! This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. ! This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. ! An improper ground may cause electric shock or equipment damage. Do not excessively bend the plug and wire nor place heavy objects upon them, which could cause damage. ! This may cause an electric shock or fire. Do not connect too many extension cords or plugs to an outlet. ! This may cause a fire. Put your monitor in a location with low humidity and a minimum of dust. ! An electric shock or fire could result inside the monitor. Notational Power Installation Cleaning Other ! Do not drop the monitor when moving it. This may cause damage to the product or human body. Place the monitor on a flat and stable surface. ! The monitor can cause injury by falling. Set down the monitor carefully. ! It could be damaged or broken. Do not place the monitor face down. ! The TFT-LCD surface may be damaged. Installing a wall bracket must be done by a qualified professional. ! Installation by unqualified personnel may result in injury. Always use the mounting device specified in the owner's manual. ! Leave a space for ventilation between the product and the wall. ! Poor ventilation may cause the interior temperature to rise and lead to a fire. When cleaning the monitor case or the surface of the TFT-LCD screen, wipe with a slightly moistened, soft fabric. Notational Power Installation Do not spray water or detergent directly on the monitor. ! Cleaning Other This may cause damage, electric shock or a fire. Use the recommended detergent with a smooth cloth. If the connector between the plug and the pin is dusty or dirty, clean it properly with a dry cloth. ! A dirty connector can cause an electric shock or fire. Contact a Service Center or Customer Center for interior cleaning once a year. ! Keep the product's interior clean. [. . . ] " In this case, check the computer for trouble. General Model Name LCD Panel Size General PowerSaver Preset Timing Modes SyncMaster 173VT 17. 0 inch diagonal 337. 92 (H) x 270. 336 (V) 0. 264 (H) x 0. 264 (V) a-si TFT active matrix Display area Pixel Pitch Type Synchronization Horizontal Vertical Display Color 16, 194, 277 Resolution Optimum resolution Maximum resolution Input Signal, Terminated RGB Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, Composite, TTL level positive or negative Maximum Pixel Clock 135 MHz Power Supply AC 90 ~ 264 VAC rms, 60/50 Hz ± 3Hz Signal Cable 15pin-to-15pin D-sub cable, detachable Power Consumption Less than 45W Dimensions (WxDxH) / Weight 384. 6 X 66. 7 X 338. 0 mm (Without stand) 384. 6 X 201. 0 X 392. 8 mm / 5. 4kg (With basic stand) Dimensions (WxDxH) / Weight (Protection Glass) 384. 6 X 66. 7 X 338. 0 mm (Without stand) 384. 6 X 201. 0 X 392. 8 mm / 6. 0kg (With basic stand) VESA Mounting Interface 75mm x 75mm (for use with Specialty(Arm) Mounting hardware. ) Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Dot Acceptable TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99. 999% above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness. ! 30 ~ 81 kHz 56 ~ 75 Hz 1280 x 1024@60Hz 1280 x 1024@75Hz Temperature: 50°F ~ 104°F(10°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing For example, the no. of TFT LCD pixels that is contained in this product are 3, 932, 160. Note: Design and specifications are subject to change without prior notice. General Model Name General PowerSaver Preset Timing Modes SyncMaster 710VT LCD Panel Size Display area Pixel Pitch Type Synchronization Horizontal Vertical Display Color 16, 194, 277 Resolution Optimum resolution Maximum resolution Input Signal, Terminated RGB Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, Composite, TTL level positive or negative Maximum Pixel Clock 135 MHz Power Supply AC 90 ~ 264 VAC rms, 60/50 Hz ± 3Hz Signal Cable 15pin-to-15pin D-sub cable, detachable Power Consumption Less than 45W Dimensions (WxDxH) / Weight 384. 6 X 66. 7 X 338. 0 mm (Without stand) 384. 6 X 201. 0 X 392. 8 mm / 5. 4kg (With basic stand) VESA Mounting Interface 75mm x 75mm (for use with Specialty(Arm) Mounting hardware. ) Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Dot Acceptable TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99. 999% above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness. Temperature: 50°F ~ 104°F(10°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing 1280 x 1024@60Hz 1280 x 1024@75Hz 30 ~ 81 kHz 56 ~ 75 Hz 17. 0 inch diagonal 337. 92 (H) x 270. 336 (V) 0. 264 (H) x 0. 264 (V) a-si TFT active matrix For example, the no. of TFT LCD pixels that is contained in this product are 3, 932, 160. Note: Design and specifications are subject to change without prior notice. General PowerSaver Preset Timing Modes This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use a software utility installed on your computer to set up this feature. Power saving mode EPA / ENERGY 2000 Green Blinking Less than 2W State Power Indicator Power Consumption Normal Operation Green Less than 45W Power off Black Less than 1W (110 Vac) This monitor is EPA ENERGY STAR ® compliant and ENERGY2000 compliant when used with a computer equipped with VESA DPMS functionality. As an ENERGY STAR® Partner, SAMSUNG has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. [. . . ] Select Natural Color from the list and then click the [Add/Delete] button. For Better Display 1. Adjust computer resolution and screen injection rate (refresh rate) in control panel of computer as described below to enjoy the best quality of picture. You can have an uneven quality of picture in the screen if the best quality of picture is not provided in TFT-LCD. !! Service Terms Regulatory Natural Color Resolution: 1280 x 1024 Vertical frequency (refresh rate): 60 Hz For Better Display Authority 2. [. . . ]