User manual SAMSUNG SYNCMASTER 714BM

[. . . ] SyncMaster 714BM Install driver Install programs Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to the equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Ground to prevent an electric shock Power When not used for an extended period of time, set your computer to DPM. If using a screen saver, set it to active screen mode. The images here are for reference only, and are not applicable in all cases (or countries). Do not use a damaged or loose plug. This may cause electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. [. . . ] You may relocate it to the center using the Horizontal Control menu. (Available in analog Mode Only) [MENU , , MENU] Fine Removes noise such as horizontal stripes. If the noise persists even after Fine tuning, repeat it after adjusting the frequency (clock speed). (Available in analog Mode Only) [MENU , , , MENU] Sharpness Changes the clearance of image. (Not available in MagicColor mode of Full and Intelligent. ) [MENU , , , MENU] H-Position Changes the horizontal position of the monitor's entire display. (Available in analog Mode Only) [MENU , , , MENU] V-Position Changes the vertical position of the monitor's entire display. (Available in analog Mode Only) [MENU , , , MENU] OSD Menu Description Play/Stop You can choose one of the nine languages. Language Note:The language chosen affects only the language of the OSD. It has no effect on any software running on the computer. [MENU , , MENU] H-Position You can change the horizontal position where the OSD menu appears on your monitor. [MENU , , , MENU] V-Position You can change the vertical position where the OSD menu appears on your monitor. [MENU , Transparency , , MENU] Change the transparency of the background of the OSD. [MENU , , , MENU] Display Time The menu will be automatically turned off if no adjustments are made for a certain time period. You can set the amount of time the menu will wait before it is turned off. [MENU , , , MENU] Setup Menu Description Play/Stop Auto Source Select Auto Source for the monitor to automatically select the signal source. [MENU , , MENU] Image Reset Image parameters are replaced with the factory default values. [MENU , , , MENU] Color Reset Color parameters are replaced with the factory default values. [MENU , , , MENU] Information Menu Description Shows a video source, display mode on the OSD screen. Information [MENU , MENU] Installation 1. Insert the installation CD into the CD-ROM drive. Click the MagicTuneTM installation file. Select installation Language, Click "Next". When the Installation Shield Wizard window appears, click "Next. " Select "I agree to the terms of the license agreement" to accept the terms of use. Choose a folder to install the MagicTuneTM program. [. . . ] During normal operation of a LCD panel, pixel image retention doesn't occur. However, if the same image is displayed for a long time, a slight difference in electric charge accumulates between the two electrodes which encase the liquid crystal. This may cause the liquid crystal to build up in a certain areas of the display. Thus, the previous image is retained when switching to a new video image. [. . . ]