User manual SAMSUNG SYNCMASTER 760B

[. . . ] SyncMaster 760B / 960B Install drivers Install programs Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Power When not used for extended period of time, set your computer to DPMS. If using a screen saver, set it to the active screen mode. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. [. . . ] An error occurs when no information on EDID (Extended Display Identification Data) exists for the current monitor. This happens when from your desktop, Start Setup Control Panel System Hardware Device Manager Monitor is selected, the current "Plug-and-play monitor" is removed and new hardware is searched for but the system couldn't find any "Plug-and-play monitor". Please visit our homepage to see the Troubleshooting section. An error occurs when replacing the monitor with a new one when the system power is off but the system has not been restarted. Please restart the system each time the monitor is replaced before using MagicTuneTM. An error occurs when the video card driver is not installed properly. This happens when the current video card list is not displayed normally. You can check this via Start Setup System Hardware Device Manager Display Adapter. Visit the video card maker's homepage and download and install the latest driver. For more information about the video card, contact the card manufacturer. To ensure normal operation, please restart your system. An error occurs when the system is not restarted after installing MagicTuneTM. (This is for Win98SE and WinMe only. ) Restart the system before use. For the best performance of MagicTuneTM, adjust to the optimal resolution. Refer to the User Guide for the optimal resolution. If you do not adjust to the optimal resolution and perform Color Calibration, the monitor cannot be adjusted to the optimal condition. Refer to the manual for the optimal resolution. This video card does not support MagicTuneTM. An error occurs when the video card driver is not installed properly. This happens when the current video card list is not displayed normally. You can check this from Start Setup System Hardware Device Manager Display Adapter. Visit the video card manufacturer's homepage and download and install the latest driver. For more information about the video card, contact the card manufacturer. As the Highlight program uses the communication lines, please exit the Highlight program before you can access MagicTuneTM. Some of Samsung CDT monitors support the Highlight feature. When using both the Highlight feature and MagicTuneTM simultaneously, conflicts occur, which cause errors. [. . . ] However, if the same image is displayed for a long time, a slight difference in electric charge accumulates between the two electrodes which encase the liquid crystal. This may cause the liquid crystal to build up in a certain areas of the display. Thus, the previous image is retained when switching to a new video image. All display products, including LCD, are subject to image retention. [. . . ]