User manual SAMSUNG SYNCMASTER 773S

[. . . ] SyncMaster 773DFX index MinPg a ae Sfe Intrutio s a ty s c n Nta nl o tio a Pwr oe Inta tio s lla n C a in le n g Oe thr O-Sre nD p y n c e is la T u le h o g ro b s o tin Ce kL t hc is QA & Slf-T s Fa reCe k e e t e tu hc In d c n tro utio Upc in na k g Fn ro t Ra er Bttm o Se ific tio s pc a n Gnra Se ific tio s e e l pc a n PowerSaver Preset Timing Modes In rmtio fo a n Stu ep Cn e tin Yu Mn r o nc g o r o ito Base Installation Srv e e ic T rm es Rg la ry e u to Ntu l Clo a ra o r Ath rity uo Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Power When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. If the size of your monitor is small, or if the same image is present for long periods of time, you may see afterimages due to damage to the fluorescent substance on the inside of the CRT. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. [. . . ] Degauss the monitor if any devices were removed from the area. A monitor recreates visual signals received from the PC. Therefore, if there is trouble with the PC or the video card, this can cause the monitor to become blank, have poor coloring, noise, Sync. In this case, first check the source of the problem, and then contact a service center or your dealer. Judging the monitor's working condition If there is no image on the screen or an "Sync. Out of Range" message comes up, disconnect the cable from the computer while the monitor is still powered on. If there is a message coming up on the screen or if the screen goes white, this means the monitor is in working condition. In this case, check the computer for trouble. General Specifications General Model Name Picture Tube Type Deflection angle Dot Pitch Screen type 17"(43cm) DynaFlat X (40. 6cm viewable) 90 ° 0. 20mm (Horizontal) Aluminized tri-color phosphor dot trio with black matrix. SyncMaster 773DFX Maximum Resolution 1280 Dots, 1024 Lines Active Display Horizontal Vertical Synchronization Horizontal Vertical Input Signal Definition Video Signal Sync Signal Display Color Unlimited Maximum Pixel Clock 110 MHz Power Supply 90 ~ 264VAC rms, 60/50 Hz ± 3Hz Power Consumption 80W (Nom. ) Dimensions (WxDxH) 402 x 411 x 357mm (with Stand) Weight 15. 5 kg Environmental considerations Operating Temperature 32°F ~ 104°F(0°C ~ 40°C) Humidity 10% ~ 80%, non-condensing Storage Temperature -4°F ~113°F (-20°C ~ 45°C) Humidity 5% ~ 95%, non-condensing Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Note: Design and specifications are subject to change without prior notice. RGB, Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, TTL level, positive or negative 30 ~ 70 kHz 50 ~ 160 Hz 312 ± 4 mm 234 ± 4 mm PowerSaver This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you move the computer's mouse or press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use a software utility installed on your computer to set up this feature. State Power Indicator Power Consumption Normal Operation Green 80W(Nominal) Power-off Mode EPA/ENERGY 2000 Green, Blinking Less than 2W This monitor is EPA ENERGY STAR® compliant and ENERGY2000 compliant when used with a computer equipped with VESA DPMS functionality. As an ENERGY STAR® Partner, SAMSUNG has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. Preset Timing Modes If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows. Preset Timing Modes Display Mode IBM, 640 x 480 IBM, 720 x 400 VESA, 640 x 480 VESA, 640 x 480 VESA, 800 x 600 VESA, 1024 x 768 Horizontal Frequency (kHz) 31. 469 31. 469 37. 500 43. 269 53. 674 68. 677 Vertical Frequency (Hz) 59. 940 70. 087 75. 000 85. 008 85. 061 84. 997 Pixel Clock (MHz) 25. 175 28. 322 31. 500 36. 000 56. 250 94. 500 Sync Polarity (H/V) -/-/+ -/-/+/+ +/+ Horizontal Frequency The time to scan one line connecting the right edge to the left edge of the screen horizontally is called Horizontal Cycle and the inverse number of the Horizontal Cycle is called Horizontal Frequency. [. . . ] Some of the features of the TCO'03 Display requirements: Ergonomics · Good visual ergonomics and image quality in order to improve the working environment for the user and to reduce sight and strain problems. Important parameters are luminance, contrast, resolution, reflectance, colour rendition and image stability. Energy-saving mode after a certain time ­ beneficial both for the user and the environment Electrical safety Electromagnetic fields Noise emissions The product must be prepared for recycling and the manufacturer must have a certified environmental management system such as EMAS or ISO 14 000 Restrictions on o chlorinated and brominated flame retardants and polymers o heavy metals such as cadmium, mercury and lead. Energy · · · · · Emissions Ecology · The requirements included in this label have been developed by TCO Development in cooperation with scientists, experts, users as well as manufacturers all over the world. Since the end of the 1980s TCO has been involved in influencing the development of IT equipment in a more user-friendly direction. [. . . ]