User manual SAMSUNG SYNCMASTER 920LM

[. . . ] SyncMaster 920LM Install drivers Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to the equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Ground to prevent an electric shock Power When not used for an extended period of time, set your computer to DPM. If using a screen saver, set it to active screen mode. The images here are for reference only, and are not applicable in all cases (or countries). Do not use a damaged or loose plug. This may cause electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. [. . . ] The next screen is for selecting a keyboard. The next screen is for setting your monitor. First of all, set a horizontal frequency for your monitor. (You can enter the frequency directly. ) 8. Set a vertical frequency for your monitor. (You can enter the frequency directly. ) 9. This information will not affect the actual execution of X-Window. You have finished setting up your monitor. Execute X-Window after setting other requested hardware. [MENU/ ]Use this button to open the on-screen menu and exit from the menu screen or close screen adjustment menu. [ ]These buttons allow you to adjust items in the menu. [ ]Press this button to activate a highlighted menu item. [AUTO]Press to self-adjust to the incoming PC signal. The values of fine, coarse and position are adjusted automatically. AUTO Menu Description When the 'AUTO' button is pressed, the Auto Adjustment screen appears as shown in the animated screen on the center. Auto adjustment allows the monitor to self-adjust to the incoming video signal. The values of fine, coarse and position are adjusted automatically. AUTO To make the automatic adjustment function sharper, execute the 'AUTO' function while the AUTO PATTERN is on. - If auto adjustment does not work properly, press AUTO button again to adjust picture with more accuracy. - If you change resolution in the control panel, auto function will be executed automatically. OSD Lock & Unlock When pressing the AUTO button after locking the OSD When pressing the MENU button after locking the OSD Menu Description This is the function that locks the OSD in order to keep the current states of settings or prevent others from adjusting the current settings. Lock : Hold down the menu button for more than five seconds to activate the OSD adjustment lock function. OSD Lock & Unlock Unlock : Hold down the menu button for more than five seconds to deactivate the OSD adjustment lock function. Though the OSD adjustment lock function is activated, you can still adjust the brightness and contrast, and adjust MagicBright ( ) using the Direct button. MagicBrightTM Menu MagicBrightTM Description Push the MagicBright button to circle through available preconfigured modes. - Six different modes (Custom/Text/Internet/Game/Sport/Movie) Volume Menu Volume Description When OSD is not on the screen, push the button to adjust volume. Picture Color Image OSD Setup Information Brightness Color Tone Coarse Language Image Reset Contrast Color Control Fine H-Position Color Reset Gamma Sharpness V-Position H-Position Transparency V-Position Display Time Picture Menu Brightness Description You can use the on-screen menus to change the brightness according to personal preference. [MENU , MENU] Play/Stop Contrast You can use the on-screen menus to change the contrast according to personal preference. [MENU , , MENU] Color Menu Description The tone of the color can be changed and one of four modes can be selected - Cool, Normal, Warm and Custom. Custom - Select this mode when you want to adjust the image according to your preferences. [MENU , , , MENU] Play/Stop Color Tone Color Control Adjusts individual R, G, B color balance. [MENU , , , , MENU] Gamma correction changes the luminance of the colors with intermediate luminance. [. . . ] During normal operation of a LCD panel, pixel image retention doesn't occur. However, if the same image is displayed for a long time, a slight difference in electric charge accumulates between the two electrodes which encase the liquid crystal. This may cause the liquid crystal to build up in a certain areas of the display. Thus, the previous image is retained when switching to a new video image. [. . . ]